$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x MTF0063 Manual Gear oil
5 x SCNA Christmas Calendar
2 x PPC 3 Volvo Diagnostic System
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
3 x 9-3 ng900 radio wires
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Rivetnuts Pair (2pcs)
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Injectors Siemens 80lb 875cc (set 4)
2 x Moog Ball Joint
1 x AEM Wideband Gauge Kit
1 x Fuel Pressure Regulator 4.0 bar
2 x T5 3.0 Bar Map Sensor Adaptor
3 x Head Bolt Washers
4 x IAT Weld Bung T5/Bosch
2 x Map/MAT sensor weld bung
2 x Intake Flange B2x4 T5
1 x Injectors Green Giant 42lb (set 4)
2 x Universal / Special Request
2 x PPC - Upgrade from stage 1 to stage 3
3 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Midpipe 2.8T XWD (4wd)
5 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x BSR Optiflow Replacement Filter V6 2.8
2 x Optical Cable Connector (Onstar Delete)
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Hood Emblem 9-3 SS/sc 03- All
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x 9-3 / 900 Uprated Front ARB Bushings
3 x 3 Point Hardware
2 x Ignition Coil 9-3SS 2.8t and 2.8T
3 x 9-5 Blend Flap Limit Lever 99-04
2 x Oil Cap 9-3SS "Ghost"
2 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-5 Shift Knobs Leather
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-3 ng900 Hood Protection Strip
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x 9-5 Textile Mats 98-07
2 x Air Filter 06 version (All 9-5)
1 x Metal Steering Wheel Buttons
1 x Floormats BSR 9-3SS/SC
2 x 9-5 Aero Sill Protection
1 x Coreganizer
1 x 9-3/NG900 Shift Knobs Leather
2 x Aero Clutch Kit 9-5
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x 9-5 Wheel 10-Spoke 16in.
1 x Antenna Plug NG900/9-3 hatchback
2 x Adaptor Harness Handsfree 01-
1 x 9-3 /NG900 Grille
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x 9-5 Rear Brake rotor See Description
2 x Basic Subframe Brace
1 x Shifter Alignment Pins (Set 2)
2 x K&N Filter Service Kit
2 x Oil Cap 9-3SS V6 "Ghost"
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
3 x Crush Sleeve F35 F25
3 x Brake Vac pump seals
1 x Cat back for Viggen 2.5in
1 x Transmission Nut F35 F25
2 x Oil Cooler Adaptor B2X5
2 x B207 Upper Radiator Coolant T
1 x V6 Tank Float - SparePart
1 x Front Camber Adjustment Bolts
1 x Saab black Keychain
2 x Oil Cap 9-3SS V6 "Griffin"
2 x Oil Cap GM "HHR"
1 x v6oilcoolplate
2 x Mass Airflow Meter T7
2 x Replacement Hardware Pack 6-Point
1 x Replacement Filter for Open air 9-3 T7
2 x Fuel Line Clip
1 x Direct Ignition T7 Black
1 x Crank Vent Kit #6 T7 4cyl
1 x Direct Ignition T5 RED
2 x Flex Pipe 900 94-98 9-3 99-02
2 x Rear Engine Mount 4cyl
2 x Remote Button NG900
1 x Oil Pressure Switch
1 x Coolant Bypass Valve 9-5
2 x Cabin Vent Fan
3 x Exhaust manifold Stud Kit
1 x 9-5 Intercooler ETS
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Clear Little Fender Blinkers Factory Saab
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Downpipe Hardware Kit
1 x Griffin logo Shifter Top
2 x Oil Filter Re-locator
1 x Flywheel Twin Disk 7.25in B2xx
1 x 20th Viggen logo Shifter Top
1 x Machined Control Arm Kit
1 x Rear Camber Shims Kit 6pcs
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Shift Rod Bushings
1 x Steering Coupler 9-3 99-02
1 x v6 header flange
2 x 9-5 Exhaust Flex Pipe Stainless
1 x Troll Head Plug
1 x Midpipe 2.8T FWD (2wd)
2 x Shifter Top Ghost Logo
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Mat Set Black Rubber 9-5 10-
1 x Genuine Saab 4cyl Oil Filters
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Downpipe 2.8T FWD (2wd)
2 x Con Rods V6 2.8L 155.8mm
1 x Limit Strap Coilover Add On Kit
2 x Rear spring perches Adjustable NG900/9-3
1 x Downpipe 2.8T XWD (4wd)
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x ShortShift Kit 93ss
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x Rear Rotors PAIR 278mm Plain (Code: BA)
2 x Rear Brake Pads 9-3 SS
1 x Viggen Front Brake Disk Pair 308mm
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x ATF Saab 3309 (Automatic 02->)
1 x Bulb Switch Light
1 x Headbolts (New Style)
1 x Exhaust Clamp Kit
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Fog light 9-3 Right 99-00
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Fog light 9-3 left 99-00
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x 9000 High Performance Brake Line Kit '95-'98
1 x 4 Cyl 2.0 Coolant Tank
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
$31,289.33
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail