$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Flex Pipe 900 94-98 9-3 99-02
3 x Remote Button NG900
3 x Direct Ignition T5 RED
4 x Fuel Line Clip
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x 9-5 Blend Flap Limit Lever 99-04
3 x PPC 3 Volvo Diagnostic System
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x K&N Filter Service Kit
1 x ATF Saab 3309 (Automatic 02->)
2 x MTF0063 Manual Gear oil
2 x Shifter Alignment Pins (Set 2)
2 x 9-3/NG900 Shift Knobs Leather
2 x PPC - Upgrade from stage 1 to stage 3
1 x Viggen Fog Air Intake
2 x T7 Injector Spacer Kit
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Oil Cooler Adaptor B2X5
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Throttle Bend for T5 94-99
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Flywheel Twin Disk 7.25in B2xx
1 x Quaife Differential 9-5 and Viggen (F35)
1 x 4340 Connecting Rods B204 B235
1 x JE Piston Rings 90.0mm 235/205
1 x Cat back for Viggen 2.5in
3 x Turbo Bypass Valve
2 x Shift Rod Bushings
2 x c900 Performance Brake lines
3 x Crank Vent Kit #6 T7 4cyl
1 x Crush Sleeve F35 F25
2 x Replacement Filter for Open air 9-3 T7
2 x Replacement Hardware Pack 6-Point
1 x Throttle Body T7
1 x Exhaust Clamp Kit
2 x Genuine Saab 4cyl Oil Filters
1 x Downpipe 2.8T XWD (4wd)
2 x Metal Steering Wheel Buttons
2 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Adaptor Harness Handsfree 01-
1 x ShortShift Kit 93ss
1 x BSR Optiflow Intake V6 2.8t
1 x Con Rods V6 2.8L 155.8mm
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Injectors 175hp Stg3 (Set4)
1 x Coreganizer
2 x Floormats BSR 9-3SS/SC
1 x BSR Optiflow Replacement Filter V6 2.8
3 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Shifter Mount Kit 93ss
1 x B207 Coolant Cap
3 x Midpipe 2.8T FWD (2wd)
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Front Camber Adjustment Bolts
1 x Rear spring perches Adjustable NG900/9-3
2 x Brake Vac pump seals
1 x Transmission Nut F35 F25
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Rear Pedestal Spoiler 9-3 SS
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x B207 Upper Radiator Coolant T
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Replacement V6 Coolant Cap
1 x Headlight Connector Repair Kit 9-3SS 9-5
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Short Shifter HHR Cobalt F35 F40
2 x 9-5 Exhaust Flex Pipe Stainless
2 x Midpipe 2.8T XWD (4wd)
1 x Limit Strap Coilover Add On Kit
2 x IAT Weld Bung T5/Bosch
2 x Head Bolt Washers
1 x Oil Cap 9-3SS "Ghost"
2 x Brembo Brake Kit 315mm 9-3 SS
1 x Floormats BSR 9-3 99-02 900 94-98
1 x BSR Optiflow Intake 4cyl w SAI
1 x 9000 Intercooler ETS
1 x 9000 Shifter Bushing Repair Kit
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Exhaust manifold Stud Kit
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Oil Cap GM "HHR"
1 x Oil Cap 9-3SS V6 "Ghost"
1 x 9-5 Aero Sill Protection
1 x Clear Little Fender Blinkers Factory Saab
1 x v6oilcoolplate
1 x 3 Point Hardware
1 x Rear Brake Pads 9-3 SS
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Steering Rod Bushings NG900/93
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Machined Control Arm Kit
1 x Brembo Kit 315mm Hawk HPS Pads
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Open Air Intake 9000 93-98
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
$31,778.56
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail