$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Moog Ball Joint
4 x Downpipe Hardware Kit
2 x Con Rods V6 2.8L 155.8mm
4 x Genuine Saab 4cyl Oil Filters
4 x Mass Airflow Meter T7
3 x Limit Strap Coilover Add On Kit
5 x Flex Pipe 900 94-98 9-3 99-02
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
4 x Transmission Nut F35 F25
3 x Cat back for Viggen 2.5in
3 x Alu Hybrid Flywheel For NG900/9-3
3 x ARP Exhaust Manifold Stud kit Stainless
4 x Sport Transmission Mount 9-3/900 (Automatic)
3 x Aluminum Flywheel For NG900/9-3
3 x Exhaust manifold Stud Kit
2 x ARP Ring Gear Bolts F25/F35
1 x Replacement Flywheel Insert NG900/9-3
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Rear spring perches Adjustable NG900/9-3
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Injectors Green Giant 42lb (set 4)
3 x Steering Coupler 9-3 99-02
1 x Universal / Special Request
1 x PPC - Upgrade from stage 1 to stage 3
2 x Map/MAT sensor weld bung
3 x Basic Subframe Brace
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Fuel Pressure Regulator 4.0 bar
1 x Steering Rod Bushings NG900/93
3 x Injectors Siemens 80lb 875cc (set 4)
1 x Injectors Siemens 60lb 630cc (set 4)
2 x T5 3.0 Bar Map Sensor Adaptor
1 x Rear Camber Shims Kit 6pcs
1 x Head Bolt Washers
1 x AEM Wideband Gauge Kit
1 x Intake Flange B2x4 T5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Headbolts (New Style)
1 x JE Piston Rings 90.0mm 235/205
1 x Rod Bearings only Pauter Rods
2 x 4340 Connecting Rods B204 B235
1 x Oil Filter Re-locator
1 x Head Stud Kit all 4cyl
3 x T7 Head Plug NGK
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Clear Little Fender Blinkers Factory Saab
1 x ATF Saab 3309 (Automatic 02->)
2 x Adaptor Harness Handsfree 01-
2 x Griffin logo Shifter Top
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
3 x Replacement Filter for Open air 9-3 T7
1 x 9-5 Aero Sill Protection
2 x Turbo Bypass Valve
1 x Direct Ignition T5 RED
2 x Crank Vent Kit #6 T7 4cyl
3 x Throttle Body T7
4 x Crush Sleeve F35 F25
2 x Fuel Line Clip
1 x Remote Button NG900
3 x B207 Upper Radiator Coolant T
2 x PPC 3 Volvo Diagnostic System
2 x V6 Tank Float - SparePart
2 x Brake Vac pump seals
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Front Camber Adjustment Bolts
1 x Oil Cap 9-3SS "Ghost"
4 x Oil Cap GM "HHR"
1 x Exhaust Clamp Kit
1 x Troll Head Plug
2 x c900 Performance Brake lines
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Shift Rod Bushings
1 x Replacement V6 Coolant Cap
1 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x 3 Point Hardware
2 x Sparkplugs 9-3SS
2 x Ignition Coil 9-3SS 2.8t and 2.8T
2 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Hood Emblem 9-3 SS/sc 03- All
2 x 9-3 99-02,03 CV Antenna Adaptor
3 x Forge Bypass Valve Cobalt/HHR TC
3 x Shifter Mount Kit Cobalt/ HHR
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Short Shifter HHR Cobalt F35 F40
1 x MTF0063 Manual Gear oil
2 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x BSR Optiflow Intake 4cyl
1 x B207 Coolant Cap
2 x Replacement Hardware Pack 6-Point
3 x Rear Engine Mount 4cyl
1 x 9-5 High Performance Brake Line Kit
1 x Quaife Differential 9-5 and Viggen (F35)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x 9-3/NG900 Shift Knobs Leather
1 x Upgrade Valve Springs T5 Cars
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Custom Brake Lines RR 300mm Kit
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Rivetnuts Pair (2pcs)
1 x 9000 Intercooler ETS
1 x 9-5 Intercooler ETS
1 x Viggen Clutch Kit 99-02
1 x Shifter Top Ghost Logo
1 x Slave Cyl
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Brembo Kit 315mm Hawk HPS Pads
1 x Rear Brake Pads 9-3 SS
$32,791.83
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail