$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x IAT Weld Bung T5/Bosch
3 x Head Bolt Washers
2 x Universal / Special Request
2 x Fuel Pressure Regulator 4.0 bar
3 x T5 3.0 Bar Map Sensor Adaptor
1 x Injectors Siemens 80lb 875cc (set 4)
3 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x AEM Wideband Gauge Kit
3 x Intake Flange B2x4 T5
2 x Injectors Green Giant 42lb (set 4)
2 x Moog Ball Joint
7 x PPC - Upgrade from stage 1 to stage 3
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
4 x Rivetnuts Pair (2pcs)
2 x Injectors Siemens 60lb 630cc (set 4)
3 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Con Rods V6 2.8L 155.8mm
2 x Midpipe 2.8T FWD (2wd)
2 x InjectorDynamics 725cc For 2.8V6 (Set6)
2 x BSR Optiflow Replacement Filter V6 2.8
3 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
4 x PPC 3 Volvo Diagnostic System
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Shifter Mount Kit Cobalt/ HHR
2 x 3 Point Hardware
1 x Optical Cable Connector (Onstar Delete)
1 x B207 Upper Radiator Coolant T
2 x Brake Vac pump seals
2 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x 9-3 / 900 Uprated Front ARB Bushings
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Hood Emblem 9-3 SS/sc 03- All
1 x V6 Tank Float - SparePart
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x 20th Viggen logo Shifter Top
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Sparkplugs 9-3SS
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Replacement V6 Coolant Cap
2 x Rear Pedestal Spoiler 9-3 SS
1 x SCNA Christmas Calendar
3 x Storage Tray / Ashtray Kit 9-5 10-
2 x Mat Set Textile Jet Black 9-5 10-
3 x v6oilcoolplate
3 x Oil Cap 9-3SS V6 "Ghost"
2 x Oil Cap 9-3SS "Ghost"
3 x Oil Cap 9-3SS V6 "Griffin"
3 x v6 header flange
3 x v6 2.8t SAI Delete Kit
2 x Turbo to Downpipe Flange B207
1 x Midpipe 2.8T XWD (4wd)
3 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x Injectors 175hp Stg3 (Set4)
3 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Fuel Line Clip
1 x Direct Ignition T7 Black
4 x Slave Cyl
1 x 4340 Connecting Rods B204 B235
2 x Downpipe Hardware Kit
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-3 ng900 radio wires
1 x Fog light 9-3 Right 99-00
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x JE Piston Rings 90.0mm 235/205
3 x Adaptor Harness Handsfree 01-
1 x Aluminum Flywheel For NG900/9-3
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Fog light Replacement Panels
1 x Crank Vent Kit #6 T7 4cyl
2 x Viggen Fog Air Intake
2 x Map/MAT sensor weld bung
1 x 9-3 Rear Ashtray
2 x Clear Little Fender Blinkers Factory Saab
1 x Headbolts (New Style)
1 x Replacement Filter for Open air 9-3 T7
1 x Replacement Hardware Pack 6-Point
4 x T7 Injector Spacer Kit
4 x Rear Camber Shims Kit 6pcs
2 x Cat back for Viggen 2.5in
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
3 x Exhaust Clamp Kit
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
3 x Exhaust manifold Stud Kit
1 x Front Camber Adjustment Bolts
1 x Shifter Top Ghost Logo
1 x BSR 9-5 260Hp 2006-
2 x Bulb Switch Light
1 x Saab black Keychain
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x BSR Optiflow Intake 4cyl
2 x BSR 9-5 3.0T V6 200Hp
1 x Cigarette Lighter
1 x Floormats BSR 9-5
1 x 9-5 Textile Mats 98-07
2 x 9-5 Shift Knobs Leather
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
3 x Shifter Alignment Pins (Set 2)
1 x Brembo Brake Kit 315mm 9-3 SS
2 x Shift Rod Bushings
1 x Weld Bungs -Taper- Race Only
1 x Downpipe 2.8T FWD (2wd)
1 x Griffin logo Shifter Top
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x BSR Optiflow Intake V6 2.8t
4 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x K&N Filter Service Kit
2 x Basic Subframe Brace
1 x Genuine Saab 4cyl Oil Filters
2 x Limit Strap Coilover Add On Kit
1 x T7 Head Plug NGK
1 x Transmission Nut F35 F25
2 x Torque Mount Insert V6 Manual (XWD and FWD)
2 x Turbo Bypass Valve
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Short Shifter HHR Cobalt F35 F40
1 x 9-5 Rear Brake rotor See Description
1 x Crush Sleeve F35 F25
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Throttle Bend for T5 94-99
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Intercooler ETS
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Mat Set Textile Parchment 9-5 10-
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
$38,145.21
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail