$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x c900 Performance Brake lines
4 x Clear Little Fender Blinkers Factory Saab
1 x Short Shifter HHR Cobalt F35 F40
1 x Oil Cap GM "HHR"
1 x Shifter Mount Kit Cobalt/ HHR
1 x Intake Flange B2x4 T5
1 x Rivetnuts Pair (2pcs)
1 x Injectors Siemens 60lb 630cc (set 4)
2 x T5 3.0 Bar Map Sensor Adaptor
3 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x IAT Weld Bung T5/Bosch
1 x Fuel Pressure Regulator 4.0 bar
1 x Head Bolt Washers
2 x PPC - Upgrade from stage 1 to stage 3
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x AEM Wideband Gauge Kit
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Map/MAT sensor weld bung
2 x Moog Ball Joint
4 x Con Rods V6 2.8L 155.8mm
2 x Replacement V6 Coolant Cap
2 x SCNA Christmas Calendar
2 x T7 Head Plug NGK
1 x 9000 Shifter Bushing Repair Kit
3 x Rear Camber Shims Kit 6pcs
1 x 3 Point Hardware
1 x Cat back for Viggen 2.5in
1 x Throttle Bend for T5 94-99
3 x Flex Pipe 900 94-98 9-3 99-02
2 x 9-3/NG900 Shift Knobs Leather
2 x 9-3 /NG900 Grille
2 x 20th Viggen logo Shifter Top
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x Fog light Replacement Panels
2 x 9-3 99-02,03 CV Antenna Adaptor
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Griffin logo Shifter Top
2 x Antenna Plug NG900/9-3 hatchback
1 x Coreganizer
1 x 9-3 ng900 radio wires
1 x Aero Clutch Kit 9-5
3 x 9-5 Aero Sill Protection
2 x Air Filter 06 version (All 9-5)
1 x 9-5 Textile Mats 98-07
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
2 x 9-5 Shift Knobs Leather
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 9-5 Rear Brake rotor See Description
2 x Fog light 9-3 Right 99-00
2 x 9-3 ng900 Hood Protection Strip
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Basic Subframe Brace
3 x Steering Coupler 9-3 99-02
4 x Genuine Saab 4cyl Oil Filters
1 x Machined Control Arm Kit
1 x Limit Strap Coilover Add On Kit
1 x Rear spring perches Adjustable NG900/9-3
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Rear Pedestal Spoiler 9-3 SS
1 x Quaife Differential 9-5 and Viggen (F35)
3 x Cabin Vent Fan
2 x Fuel Line Clip
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x BSR 9-5 3.0T V6 200Hp
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x 9-5 Blend Flap Limit Lever 99-04
2 x BSR 9-5 260Hp 2006-
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x Crank Vent Kit #6 T7 4cyl
3 x Direct Ignition T7 Black
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
3 x Rear Engine Mount 4cyl
1 x Headlight Bulb H7 Longer Life
3 x ShortShift Kit 93ss
1 x Shifter Top Ghost Logo
1 x Flywheel Twin Disk 7.25in B2xx
2 x Midpipe 2.8T XWD (4wd)
1 x Filter 9-5 Cabin Air
3 x Crush Sleeve F35 F25
2 x Shift Rod Bushings
1 x Alu Hybrid Flywheel For NG900/9-3
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Front Camber Adjustment Bolts
1 x Transmission Nut F35 F25
1 x 9-5 Exhaust Flex Pipe Stainless
1 x 9-5 Open Air Prefilter
2 x Coolant Bypass Valve 9-5
1 x Aluminum Flywheel For NG900/9-3
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Mass Airflow Meter T7
3 x Remote Button NG900
1 x Front Camber Adjustment Bolts
2 x Downpipe Hardware Kit
1 x Replacement Filter for Open air 9-3 T7
1 x Headbolts (New Style)
1 x Shifter Mount Kit 93ss
3 x Slave Cyl
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x Oil Pressure Switch
1 x Direct Ignition T5 RED
2 x BSR Optiflow Intake 4cyl w SAI
1 x Downpipe 2.8T XWD (4wd)
2 x 9000 Intercooler ETS
1 x Exhaust manifold Stud Kit
1 x Floormats BSR 9-5
2 x Hood Emblem 9-5 All
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Floormats BSR 9-3SS/SC
1 x Hood Emblem 9-3 SS/sc 03- All
1 x B207 Upper Radiator Coolant T
1 x Injectors 175hp Stg3 (Set4)
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Sparkplugs 9-3SS
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Spec Light Flywheel For 9-5 4cyl 99-09
3 x Turbo Conversion Pipe 900 9-3 T5
1 x MTF0063 Manual Gear oil
2 x BSR Optiflow Intake 4cyl
5 x BSR Optiflow Intake V6 2.8t
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Rear Brake Pads 9-5 Later Style
2 x Troll Head Plug
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Downpipe 2.8T FWD (2wd)
1 x Oil Filter Re-locator
2 x Turbo Bypass Valve
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Optical Cable Connector (Onstar Delete)
1 x Storage Tray / Ashtray Kit 9-5 10-
2 x Fog light 9-3 left 99-00
2 x Saab black Keychain
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Custom Brake Lines RR 300mm Kit
1 x Viggen Front Brake Disk Pair 308mm
2 x Bulb Switch Light
1 x Viggen Fog Air Intake
1 x Throttle Body T7
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x v6oilcoolplate
2 x Open Air Intake 9000 93-98
2 x Oil Cap 9-3SS V6 "Ghost"
1 x Cigarette Lighter
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Replacement Flywheel Insert NG900/9-3
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Oil Cap 9-3SS V6 "Griffin"
1 x PPC 3 Volvo Diagnostic System
$40,392.23
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail