$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
5 x Storage Tray / Ashtray Kit 9-5 10-
2 x Shifter Alignment Pins (Set 2)
1 x ATF Saab 3309 (Automatic 02->)
3 x K&N Filter Service Kit
4 x MTF0063 Manual Gear oil
3 x AEM Wideband Gauge Kit
1 x IAT Weld Bung T5/Bosch
1 x Shifter Mount Kit Cobalt/ HHR
2 x Clear Little Fender Blinkers Factory Saab
2 x BSR 9-5 2010-2011 V6 300Hp
1 x Basic Subframe Brace
1 x Aero Clutch Kit 9-5
1 x Mass Airflow Meter T7
1 x BSR 9-5 260Hp 2006-
1 x Headlight Connector Repair Kit 9-3SS 9-5
2 x 9-5 Open Air Prefilter
2 x Mat Set Textile Parchment 9-5 10-
2 x Exhaust manifold Stud Kit
1 x ARP Exhaust Manifold Stud kit Stainless
3 x Filter 9-5 Cabin Air
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Air Filter 06 version (All 9-5)
1 x Drop in Sport Filter 9-5
2 x Sparkplugs 9-3SS
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Optical Cable Connector (Onstar Delete)
1 x Crank Vent Kit #6 T7 4cyl
2 x T7 Injector Spacer Kit
1 x Replacement V6 Coolant Cap
1 x Fuel Line Clip
1 x Direct Ignition T7 Black
1 x 9-5 Blend Flap Limit Lever 99-04
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x Head Stud Kit all 4cyl
1 x Brake Vac pump seals
1 x Mat Set Textile Shark Grey 9-5 10-
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
2 x Shift Rod Bushings
1 x Crush Sleeve F35 F25
1 x Hood Emblem 9-3 SS/sc 03- All
1 x 9-5 Exhaust Flex Pipe Stainless
1 x 3 Point Hardware
1 x Headbolts (New Style)
1 x V6 Tank Float - SparePart
4 x Mat Set Black Rubber 9-5 10-
1 x Downpipe Hardware Kit
1 x Slave Cyl
1 x Coolant Bypass Valve 9-5
1 x Oil Pressure Switch
2 x BSR 9-5 3.0T V6 200Hp
1 x Genuine Saab 4cyl Oil Filters
1 x Cabin Vent Fan
1 x 9-5 Intercooler ETS
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x BSR Optiflow Intake V6 2.8t
1 x BSR Optiflow Replacement Filter V6 2.8
2 x Floormats BSR 9-3SS/SC
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Con Rods V6 2.8L 155.8mm
1 x B207 Coolant Cap
2 x BSR Optiflow Intake 4cyl
1 x Front Camber Adjustment Bolts
1 x Downpipe 2.8T XWD (4wd)
3 x Adaptor Harness Handsfree 01-
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Front Camber Adjustment Bolts
1 x Mat Set Textile Jet Black 9-5 10-
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x 9-5 Textile Mats 98-07
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Direct Ignition T5 RED
1 x 9-3 / 900 Uprated Front ARB Bushings
2 x Replacement Filter for Open air 9-3 T7
1 x Turbo Conversion Pipe 900 9-3 T5
1 x 20th Viggen logo Shifter Top
1 x Rear Engine Mount 4cyl
2 x Injectors Siemens 80lb 875cc (set 4)
1 x Intake Flange B2x4 T5
1 x Weld Bungs -Taper- Race Only
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x JE Piston Rings 90.0mm 235/205
1 x Fuel Pressure Regulator 4.0 bar
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x c900 Performance Brake lines
1 x Upgrade Valve Springs T5 Cars
2 x ShortShift Kit 93ss
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Valve Cover Gasket Set 4cyl
1 x 9-3 SS Akebono Rear Pads
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Turbo to Downpipe Flange B207
1 x v6 header flange
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Oil Cap 9-3SS V6 "Ghost"
1 x PPC - Upgrade from stage 1 to stage 3
1 x Shifter Mount Kit 93ss
1 x 9-5 Aero Sill Protection
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Universal / Special Request
1 x SCNA Christmas Calendar
1 x Cat back for Viggen 2.5in
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x v6oilcoolplate
2 x Oil Cap 9-3SS "Ghost"
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Oil Cap 9-3SS V6 "Griffin"
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Coreganizer
1 x Injectors 175hp Stg3 (Set4)
1 x v6 2.8t SAI Delete Kit
1 x Midpipe 2.8T FWD (2wd)
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Saab black Keychain
1 x Open Air Intake 9000 93-98
1 x PPC 3 Volvo Diagnostic System
$26,238.85
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail