$100.00 $90.00

Rear Anti-Roll (anti Sway) Bar NG900 / 9-3
[ARB22]

Rear Anti-Roll (anti Sway) Bar NG900 / 9-3

Add to Cart

Date Added: Saturday 09 April, 2011

by Steve Beisser

Upgrade #2 (#1 - steering rack clamp kit). This upgrade GREATLY improves the tracking through turns. I used to have a hard time on a 90 degree turn staying in the inside lane on a multi-lane road. Not any more. The car goes where I point it. It almost feels like the car is being pushed through the turns now. The body roll is noticeably reduced, and the handling through turns is much quicker. Feels like the turning radius is smaller too when I took my first U-turn. Install was straight forward. It took me about 1 hour. I did not use a lift of any kind and found there was enough clearance to do the job (not enough clearance, however, to use a creeper, just worked directly on my back on the floor of my garage). The original, flimsy bar came right off (OK, I snapped the head off one bolt, but it turned out to be easy to remove the rest of the bolt once the bar was off). I didn't have a helper, so I used my floor jack to prop up one side of the bar while I installed the bolts on the other side. I found it to be a bit difficult to get the nuts on, as there is not very much clearance when placing the washer and nut over the end of the bolts, but it is doable. One caution-be carefull to avoid the brake lines when tightening the bolts, specially with the wrench that is holding the nut in place when turning the bolt head. In summary, for less than the price of 2 tanks of gas, this is another no brainer. Next up is the strut brace, then the 6 point sub-frame. Hope to have those installed in the next month or so. Thanks again Taliaferro! This upgrade stuff is quite the slippery slope! Fortunately, the prices are very reasonable so I won't end up in the poor house (but I do stand a chance of ending up in the dog house with my wife!)

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Injectors Green Giant 42lb (set 4)
1 x Con Rods V6 2.8L 155.8mm
1 x Intake Flange B2x4 T5
1 x Universal / Special Request
1 x MTF0063 Manual Gear oil
2 x 9-5 Aero Sill Protection
1 x Griffin logo Shifter Top
2 x Steering Coupler 9-3 99-02
1 x Rod Bearings only Pauter Rods
1 x Balance Shaft Tensioner Delete
1 x 9-3 Rear Ashtray
1 x JE Piston Rings 90.0mm 235/205
1 x Limit Strap Coilover Add On Kit
1 x Headbolts (New Style)
1 x Adaptor Harness Handsfree 01-
4 x Shift Rod Bushings
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x T7 Head Plug NGK
1 x Machined Control Arm Kit
1 x Oil Filter Re-locator
3 x Basic Subframe Brace
1 x Head Stud Kit all 4cyl
1 x Coreganizer
1 x 20th Viggen logo Shifter Top
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3 / 900 Uprated Front ARB Bushings
2 x Rear Camber Shims Kit 6pcs
1 x 9-3/NG900 Shift Knobs Leather
1 x PPC - Upgrade from stage 1 to stage 3
1 x Steering Rod Bushings NG900/93
1 x Exhaust Clamp Kit
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Remote Button NG900
1 x Crank Vent Kit #6 T7 4cyl
1 x Flywheel Twin Disk 7.25in B2xx
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Rear Engine Mount 4cyl
1 x T7 Injector Spacer Kit
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Fuel Line Clip
1 x Genuine Saab 4cyl Oil Filters
2 x Flex Pipe 900 94-98 9-3 99-02
2 x Oil Cooler Adaptor B2X5
1 x ARP Ring Gear Bolts F25/F35
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Transmission Nut F35 F25
1 x Crush Sleeve F35 F25
1 x Mass Airflow Meter T7
1 x Aluminum Flywheel For NG900/9-3
1 x Cat back for Viggen 2.5in
1 x 9-3 /NG900 Grille
1 x Direct Ignition T5 RED
1 x Alu Hybrid Flywheel For NG900/9-3
4 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x BSR 9-5 3.0T V6 200Hp
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Direct Ignition T7 Black
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Cigarette Lighter
1 x Forge Bypass Valve Cobalt/HHR TC
1 x 9000 Intercooler ETS
1 x 9000 High Performance Brake Line Kit '95-'98
1 x Exhaust manifold Stud Kit
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-3 ng900 Hood Protection Strip
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Aero Clutch Kit 9-5
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x BSR Optiflow Intake 4cyl
1 x Custom Brake Lines RR 300mm Kit
1 x BSR 9-5 260Hp 2006-
1 x 9-5 High Performance Brake Line Kit
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Brembo Brake Kit 315mm 9-5 02-->
$14,595.72
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail