$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x B207 Coolant Cap
3 x Replacement V6 Coolant Cap
1 x Limit Strap Coilover Add On Kit
1 x Moog Ball Joint
1 x 9000 Shifter Bushing Repair Kit
1 x 3 Point Hardware
1 x Injectors Green Giant 42lb (set 4)
1 x Rivetnuts Pair (2pcs)
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x BBS Center Cap for 9-2x RK small caps
1 x "Griffin" Valve stem caps
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x Shifter Mount Kit Cobalt/ HHR
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x c900 Performance Brake lines
2 x Shift Rod Bushings
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Transmission Nut F35 F25
1 x v6oilcoolplate
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x v6 header flange
1 x Intake Flange B2x4 T5
1 x 20th Viggen logo Shifter Top
1 x Flywheel Twin Disk 7.25in B2xx
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Oil Cap 9-3SS "Ghost"
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Drop in Sport Filter 9-5
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Rear Camber Shims Kit 6pcs
1 x Metal Steering Wheel Buttons
1 x Fog light 9-3 left 99-00
3 x Basic Subframe Brace
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Hood Emblem 9-5 All
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Oil Filter Re-locator
1 x Adaptor Harness Handsfree 01-
1 x BSR 9-5 260Hp 2006-
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x AEM Wideband Gauge Kit
1 x 9-3 SS Akebono Rear Pads
1 x V6 Tank Float - SparePart
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Filter 9-5 Cabin Air
1 x BSR 9-5 3.0T V6 200Hp
1 x BSR Optiflow Intake 4cyl
1 x Steering Coupler 9-3 99-02
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Shifter Mount Kit 93ss
1 x Clear Little Fender Blinkers Factory Saab
1 x Shifter Alignment Pins (Set 2)
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x 4340 Connecting Rods B204 B235
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Front Camber Adjustment Bolts
$10,984.83
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail