$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x MTF0063 Manual Gear oil
1 x K&N Filter Service Kit
1 x ATF Saab 3309 (Automatic 02->)
2 x Shifter Alignment Pins (Set 2)
1 x 9000 Shifter Bushing Repair Kit
1 x SCNA Christmas Calendar
1 x Con Rods V6 2.8L 155.8mm
1 x Replacement V6 Coolant Cap
1 x B207 Coolant Cap
1 x Limit Strap Coilover Add On Kit
1 x Fuel Pressure Regulator 4.0 bar
1 x PPC 3 Volvo Diagnostic System
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Replacement Filter for Open air 9-3 T7
1 x Oil Filter Re-locator
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Rear Engine Mount 4cyl
1 x T7 Head Plug NGK
1 x Remote Button NG900
1 x Mass Airflow Meter T7
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Crush Sleeve F35 F25
1 x Headbolts (New Style)
3 x Exhaust Clamp Kit
1 x Transmission Nut F35 F25
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x Basic Subframe Brace
1 x Rear Camber Shims Kit 6pcs
1 x Flywheel Twin Disk 7.25in B2xx
1 x 9-3 /NG900 Grille
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Griffin logo Shifter Top
1 x 9-3/NG900 Shift Knobs Leather
1 x Antenna Plug NG900/9-3 hatchback
2 x 20th Viggen logo Shifter Top
1 x Throttle Bend for T5 94-99
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Replacement Flywheel Insert NG900/9-3
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3 ng900 Hood Protection Strip
1 x Cat back for Viggen 2.5in
1 x 9-5 Textile Mats 98-07
1 x Genuine Saab 4cyl Oil Filters
1 x Cabin Vent Fan
1 x 4 Cyl 2.0 Coolant Tank
1 x ShortShift Kit 93ss
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Brake Vac pump seals
1 x Fog light Replacement Panels 99-01
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x BBS Center Cap for 9-2x RK small caps
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Oil Cap GM "HHR"
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Aluminum Flywheel For NG900/9-3
1 x Machined Control Arm Kit
1 x Oil Cap 9-3SS "Ghost"
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Viggen Front Brake Disk Pair 308mm
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
$9,178.44
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail