$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Oil Cap GM "HHR"
2 x Adaptor Harness Handsfree 01-
3 x T7 Head Plug NGK
1 x B207 Coolant Cap
2 x 9000 Shifter Bushing Repair Kit
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x 4340 Connecting Rods B204 B235
2 x Oil Filter Re-locator
2 x Head Stud Kit all 4cyl
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Floormats BSR 9-3 99-02 900 94-98
2 x Limit Strap Coilover Add On Kit
3 x 20th Viggen logo Shifter Top
1 x Troll Head Plug
1 x Griffin logo Shifter Top
2 x SCNA Christmas Calendar
1 x 9-3/NG900 Shift Knobs Leather
2 x JE Piston Rings 90.0mm 235/205
1 x 9-3 Rear Ashtray
1 x Headbolts (New Style)
1 x Balance Shaft Tensioner Delete
1 x 9-3 ng900 radio wires
2 x Rod Bearings only Pauter Rods
2 x Con Rods V6 2.8L 155.8mm
1 x Fog light Replacement Panels
1 x Cat back for Viggen 2.5in
2 x PPC - Upgrade from stage 1 to stage 3
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Shifter Alignment Pins (Set 2)
1 x Saab black Keychain
1 x Throttle Bend for T5 94-99
1 x Oil Cooler Adaptor B2X5
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Quaife Differential 9-5 and Viggen (F35)
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Fuel Line Clip
1 x Crush Sleeve F35 F25
1 x Alu Hybrid Flywheel For NG900/9-3
1 x AEM Wideband Gauge Kit
2 x Shift Rod Bushings
1 x Remote Button NG900
1 x Direct Ignition T5 RED
1 x Direct Ignition T7 Black
1 x Intake Flange B2x4 T5
2 x Moog Ball Joint
1 x Mass Airflow Meter T7
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Fuel Pressure Regulator 4.0 bar
1 x Exhaust Clamp Kit
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Injectors Green Giant 42lb (set 4)
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Short Shifter HHR Cobalt F35 F40
1 x Forge Bypass Valve Cobalt/HHR TC
1 x MTF0063 Manual Gear oil
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Machined Control Arm Kit
1 x Upgrade Valve Springs T5 Cars
3 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Headlight Bulb H7 Longer Life
1 x Bulb Switch Light
1 x Hood Emblem 9-5 All
1 x Viggen Fog Air Intake
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Clear Little Fender Blinkers Factory Saab
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x BSR 9-5 260Hp 2006-
1 x Injectors 175hp Stg3 (Set4)
1 x Midpipe 2.8T FWD (2wd)
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Replacement Filter for Open air 9-3 T7
1 x Replacement Flywheel Insert NG900/9-3
2 x Transmission Nut F35 F25
1 x Slave Cyl
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Flywheel Twin Disk 7.25in B2xx
1 x Aluminum Flywheel For NG900/9-3
1 x Head Bolt Washers
1 x ARP Ring Gear Bolts F25/F35
1 x 3 Point Hardware
1 x Shifter Mount Kit Cobalt/ HHR
$18,687.73
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail