$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Short Shifter HHR Cobalt F35 F40
2 x Oil Cap GM "HHR"
5 x Shifter Mount Kit Cobalt/ HHR
2 x Clear Little Fender Blinkers Factory Saab
1 x c900 Performance Brake lines
2 x B207 Coolant Cap
1 x Troll Head Plug
1 x SCNA Christmas Calendar
1 x K&N Filter Service Kit
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Rivetnuts Pair (2pcs)
1 x Injectors Green Giant 42lb (set 4)
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x IAT Weld Bung T5/Bosch
2 x Moog Ball Joint
1 x Universal / Special Request
1 x Injectors Siemens 80lb 875cc (set 4)
2 x Intake Flange B2x4 T5
1 x Fuel Pressure Regulator 4.0 bar
5 x PPC - Upgrade from stage 1 to stage 3
1 x AEM Wideband Gauge Kit
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Map/MAT sensor weld bung
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Head Bolt Washers
1 x Head Stud Kit all 4cyl
2 x Oil Filter Re-locator
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Remote Button NG900
1 x Crank Vent Kit #6 T7 4cyl
1 x Direct Ignition T5 RED
1 x Direct Ignition T7 Black
2 x Headbolts (New Style)
1 x T7 Head Plug NGK
1 x Aluminum Flywheel For NG900/9-3
1 x Rear spring perches Adjustable NG900/9-3
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Floormats BSR 9-3 99-02 900 94-98
2 x BSR Optiflow Intake 4cyl
2 x BSR Optiflow Intake 4cyl w SAI
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Rear Engine Mount 4cyl
1 x Transmission Nut F35 F25
2 x Adaptor Harness Handsfree 01-
2 x Griffin logo Shifter Top
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Shifter Top Ghost Logo
1 x Steering Rod Bushings NG900/93
3 x 20th Viggen logo Shifter Top
1 x ARP Exhaust Manifold Stud kit Stainless
1 x BSR 9-5 260Hp 2006-
2 x Shift Rod Bushings
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Slave Cyl
1 x BSR 9-5 3.0T V6 200Hp
2 x BSR Optiflow Intake V6 2.8t
1 x Exhaust Clamp Kit
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Exhaust manifold Stud Kit
1 x 9-3 Rear Ashtray
1 x Steering Coupler 9-3 99-02
1 x Quaife Differential 9-5 and Viggen (F35)
1 x 9-3 ng900 radio wires
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Basic Subframe Brace
1 x Alu Hybrid Flywheel For NG900/9-3
3 x Forge Bypass Valve Cobalt/HHR TC
2 x Oil Cooler Adaptor B2X5
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Viggen Fog Air Intake
2 x T7 Injector Spacer Kit
1 x Throttle Bend for T5 94-99
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x 9-5 Aero Sill Protection
2 x Turbo Conversion Pipe 900 9-3 T5
1 x Hood Emblem 9-3 SS/sc 03- All
1 x V6 Tank Float - SparePart
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Coreganizer
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Optical Cable Connector (Onstar Delete)
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Replacement V6 Coolant Cap
2 x Brake Vac pump seals
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x B207 Upper Radiator Coolant T
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Floormats BSR 9-3SS/SC
1 x 3 Point Hardware
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Downpipe 2.8T XWD (4wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Downpipe 2.8T FWD (2wd)
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x Midpipe 2.8T FWD (2wd)
1 x MTF0063 Manual Gear oil
1 x Floormats BSR 9-5
1 x Mat Set Black Rubber 9-5 10-
1 x Shifter Mount Kit 93ss
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x 9-3 ng900 Hood Protection Strip
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
$24,101.52
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail