$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x K&N Filter Service Kit
4 x MTF0063 Manual Gear oil
1 x B207 Coolant Cap
1 x 9000 Shifter Bushing Repair Kit
2 x Replacement V6 Coolant Cap
1 x Injectors Green Giant 42lb (set 4)
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Head Bolt Washers
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
4 x Clear Little Fender Blinkers Factory Saab
1 x Antenna Plug NG900/9-3 hatchback
4 x 9-5 Aero Sill Protection
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Wheel 5-Spoke Twin 17in
2 x 9-5 Shift Knobs Leather
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
2 x Aero Clutch Kit 9-5
1 x 9-3 ng900 Hood Protection Strip
1 x 9-5 Rear Brake rotor See Description
1 x 9-5 Wheel 10-Spoke 16in.
2 x ATF Saab 3309 (Automatic 02->)
1 x Air Filter 06 version (All 9-5)
1 x 9-3/NG900 Shift Knobs Leather
1 x c900 Performance Brake lines
3 x 9-5 Textile Mats 98-07
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-3 /NG900 Grille
1 x BSR 9-5 3.0T V6 200Hp
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Shift Rod Bushings
2 x Rear Camber Shims Kit 6pcs
1 x 9-5 Intercooler ETS
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Front Camber Adjustment Bolts
2 x T7 Injector Spacer Kit
1 x Drop in Sport Filter 9-5
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Exhaust manifold Stud Kit
2 x Slave Cyl
1 x BSR 9-5 260Hp 2006-
2 x Viggen Fog Air Intake
1 x Fog light 9-3 left 99-00
2 x Fog light 9-3 Right 99-00
2 x 20th Viggen logo Shifter Top
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Adaptor Harness Handsfree 01-
1 x Turbo Conversion Pipe 900 9-3 T5
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Head Stud Kit all 4cyl
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x Cigarette Lighter
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Flywheel Twin Disk 7.25in B2xx
1 x Cat back for Viggen 2.5in
2 x Steering Rod Bushings NG900/93
2 x Genuine Saab 4cyl Oil Filters
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Machined Control Arm Kit
1 x 9-3 Rear Ashtray
2 x Coreganizer
1 x Exhaust Clamp Kit
1 x ARP Ring Gear Bolts F25/F35
1 x Short Shifter HHR Cobalt F35 F40
2 x Rear Engine Mount 4cyl
2 x Direct Ignition T7 Black
1 x 9-5 High Performance Brake Line Kit
2 x B207 Upper Radiator Coolant T
1 x 9000 High Performance Brake Line Kit '95-'98
1 x Hood Emblem 9-3 SS/sc 03- All
2 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Custom Brake Lines RR 300mm Kit
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Sparkplugs 9-3SS
2 x PPC - Upgrade from stage 1 to stage 3
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Storage Tray / Ashtray Kit 9-5 10-
2 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Headbolts (New Style)
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Crank Vent Kit #6 T7 4cyl
1 x Mat Set Textile Jet Black 9-5 10-
1 x Rear Pedestal Spoiler 9-3 SS
2 x Remote Button NG900
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Mass Airflow Meter T7
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
1 x Fuel Line Clip
1 x Headlight Bulb H7 Longer Life
1 x Open Air Intake 9000 93-98
1 x Basic Subframe Brace
1 x 9-3 ng900 radio wires
1 x Shifter Mount Kit Cobalt/ HHR
1 x Shifter Alignment Pins (Set 2)
1 x Brake Vac pump seals
1 x 3 Point Hardware
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Fog light Replacement Panels
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x 9-3 SS Akebono Rear Pads
1 x Crush Sleeve F35 F25
1 x Alu Hybrid Flywheel For NG900/9-3
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Troll Head Plug
1 x Viggen Clutch Kit 99-02
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x JE Piston Rings 90.0mm 235/205
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
$19,218.58
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail