$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Genuine Saab 4cyl Oil Filters
2 x Mass Airflow Meter T7
1 x Downpipe Hardware Kit
6 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Replacement Hardware Pack 6-Point
2 x 9-3 ng900 Hood Protection Strip
1 x Exhaust manifold Stud Kit
1 x Exhaust Clamp Kit
2 x T7 Head Plug NGK
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Con Rods V6 2.8L 155.8mm
1 x Cat back for Viggen 2.5in
2 x SCNA Christmas Calendar
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x 9000 Shifter Bushing Repair Kit
2 x Replacement V6 Coolant Cap
2 x Limit Strap Coilover Add On Kit
1 x Troll Head Plug
2 x B207 Coolant Cap
2 x Throttle Bend for T5 94-99
1 x Viggen Fog Air Intake
2 x T7 3.5 Bar Fuel Pressure Regulator
2 x Head Stud Kit all 4cyl
2 x 9-3/NG900 Shift Knobs Leather
1 x Oil Filter Re-locator
2 x Adaptor Harness Handsfree 01-
2 x JE Piston Rings 90.0mm 235/205
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 20th Viggen logo Shifter Top
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Griffin logo Shifter Top
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x Balance Shaft Tensioner Delete
1 x 4340 Connecting Rods B204 B235
1 x Headbolts (New Style)
1 x Rod Bearings only Pauter Rods
1 x Coreganizer
1 x Steering Rod Bushings NG900/93
1 x Basic Subframe Brace
3 x Rear Camber Shims Kit 6pcs
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Machined Control Arm Kit
3 x Moog Ball Joint
3 x PPC - Upgrade from stage 1 to stage 3
1 x Map/MAT sensor weld bung
1 x Fuel Pressure Regulator 4.0 bar
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Head Bolt Washers
1 x Shifter Mount Kit Cobalt/ HHR
1 x Forge Bypass Valve Cobalt/HHR TC
2 x 9-5 Aero Sill Protection
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Flywheel Twin Disk 7.25in B2xx
4 x Shift Rod Bushings
1 x Transmission Nut F35 F25
1 x Hood Emblem 9-5 All
1 x Oil Cap 9-3SS V6 "Ghost"
2 x Fog light Replacement Panels 99-01
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Quaife Differential 9-5 and Viggen (F35)
2 x Storage Tray / Ashtray Kit 9-5 10-
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Slave Cyl
1 x Mat Set Black Rubber 9-5 10-
1 x Mat Set Textile Jet Black 9-5 10-
1 x Replacement Flywheel Insert NG900/9-3
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Aero Clutch Kit 9-5
1 x ARP Ring Gear Bolts F25/F35
2 x Mat Set Textile Parchment 9-5 10-
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Turbo Bypass Valve
1 x Aluminum Flywheel For NG900/9-3
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Direct Ignition T7 Black
2 x T7 Injector Spacer Kit
1 x Floormats BSR 9-5
1 x Headlight Bulb H7 Longer Life
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x 9-5 Shift Knobs Leather
2 x Fuel Line Clip
1 x Throttle Body T7
1 x Coolant Bypass Valve 9-5
1 x 9-5 Textile Mats 98-07
1 x MTF0063 Manual Gear oil
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x v6 header flange
1 x T5 3.0 Bar Map Sensor Adaptor
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x Turbo to Downpipe Flange B207
1 x Saab black Keychain
1 x Fog light 9-3 left 99-00
2 x Fog light Replacement Panels
1 x Clear Little Fender Blinkers Factory Saab
1 x Antenna Plug NG900/9-3 hatchback
1 x Front Camber Adjustment Bolts
1 x Downpipe 2.8T FWD (2wd)
1 x PPC 3 Volvo Diagnostic System
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x 9-3 SS Akebono Rear Pads
1 x Remote Button NG900
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Replacement Filter for Open air 9-3 T7
1 x Front Camber Adjustment Bolts
1 x Fog light 9-3 Right 99-00
1 x 9-5 Open Air Prefilter
1 x 4 Cyl 2.0 Coolant Tank
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Injectors Siemens 60lb 630cc (set 4)
$21,706.01
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail