$164.69

Performance Brake Line Kit NG900 94-98 9-3 99-02
[40005]

Performance Brake Line Kit NG900 94-98 9-3 99-02

Add to Cart

Date Added: Friday 25 July, 2008

by M. Luke Wisniewski

After doing the front install, I thought others would benefit from my mistakes. I installed the kit on a MY95 900.

Tools Needed:
Flat Blade screwdriver
11,14,17mm Socket
Jack and Jack Stands
Drain Pan
10mm Flare (Brake Line) Wrench
Channel Locks
7mm Allen (Hex) wrench
19,24mm Open-End Wrench
Torque Wrench

Jack up front of vehicle and secure with jack stands.

Remove center cap and wheel/tire assembly (Flat blade and 17mm).

Place drain pan under caliper.

Remove banjo (from brake line to caliper) bolt, try to find the brass washers on both sides of the bolt (11mm socket).

Disconnect the solid brake line from flexible house, the 10mm little nut on top of the mounting tab not the 17mm on the bottom of the mounting tab. The 17mm can be used to hold the line in place if need be, I did not need to. (10mm flare wrench).

Remove clip securing the flexible line to the mounting point, slide the line out of the mounting point (channel locks).

Install new brake line to caliper, the fitting should be angled away from the caliper. Make sure to put a new brass washer on each side of the banjo bolt. Also, make sure the brake line does not interfere with accessing the caliper guide pin. (14mm socket, torque wrench, 7mm allen wrench).

Install new line into mounting point, hold bottom with 19mm wrench and tighten bolt with 24mm wrench (19,24mm wrench).

Install solid brake line into fitting on end of SS line (10mm flare wrench).

Bleed Brakes.

Re-install wheel/tire and lower vehicle.

I will write instructions for the rear lines as a separate review.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Steering Coupler 9-3 99-02
3 x ATF Saab 3309 (Automatic 02->)
1 x Oil Cap 9-3SS "Ghost"
1 x Oil Cap GM "HHR"
2 x Short Shifter HHR Cobalt F35 F40
5 x PPC - Upgrade from stage 1 to stage 3
2 x AEM Wideband Gauge Kit
2 x Universal / Special Request
3 x Moog Ball Joint
3 x IAT Weld Bung T5/Bosch
2 x Injectors Siemens 80lb 875cc (set 4)
3 x Intake Flange B2x4 T5
2 x Injectors Green Giant 42lb (set 4)
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
4 x Rivetnuts Pair (2pcs)
2 x Fuel Pressure Regulator 4.0 bar
4 x V6 Tank Float - SparePart
1 x SCNA Christmas Calendar
1 x Viggen Fog Air Intake
2 x Con Rods V6 2.8L 155.8mm
1 x 9-5 Exhaust Flex Pipe Stainless
1 x JE Piston Rings 90.0mm 235/205
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Oil Filter Re-locator
1 x Replacement Hardware Pack 6-Point
1 x Rear Engine Mount 4cyl
1 x 9-3 Rear Ashtray
2 x Exhaust Clamp Kit
2 x Fuel Line Clip
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Cat back for Viggen 2.5in
2 x 9-3/NG900 Shift Knobs Leather
1 x ARP Ring Gear Bolts F25/F35
1 x Direct Ignition T5 RED
4 x Replacement Flywheel Insert NG900/9-3
3 x Crank Vent Kit #6 T7 4cyl
2 x Alu Hybrid Flywheel For NG900/9-3
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Downpipe 2.8T FWD (2wd)
1 x Front Camber Adjustment Bolts
1 x Slave Cyl
1 x Downpipe 2.8T XWD (4wd)
2 x ShortShift Kit 93ss
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Torque Mount Insert V6 Manual (XWD and FWD)
3 x Coreganizer
2 x Quaife Differential 9-5 and Viggen (F35)
2 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Mass Airflow Meter T7
2 x Adaptor Harness Handsfree 01-
1 x Replacement Filter for Open air 9-3 T7
1 x Flywheel Twin Disk 7.25in B2xx
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
3 x Downpipe Hardware Kit
1 x Crush Sleeve F35 F25
2 x BSR Optiflow Intake 4cyl
2 x Flex Pipe 900 94-98 9-3 99-02
3 x Griffin logo Shifter Top
2 x Direct Ignition T7 Black
1 x 9-5 Aero Sill Protection
1 x Injectors 175hp Stg3 (Set4)
1 x Shifter Mount Kit 93ss
1 x Transmission Nut F35 F25
2 x Genuine Saab 4cyl Oil Filters
2 x 9-3 ng900 radio wires
1 x BSR Optiflow Intake V6 2.8t
1 x Remote Button NG900
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Shifter Top Ghost Logo
1 x Antenna Plug NG900/9-3 hatchback
2 x B207 Upper Radiator Coolant T
1 x Floormats BSR 9-3SS/SC
3 x Ignition Coil 9-3SS 2.8t and 2.8T
2 x Fog light 9-3 Right 99-00
1 x Optical Cable Connector (Onstar Delete)
1 x Metal Steering Wheel Buttons
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Rear Pedestal Spoiler 9-3 SS
1 x Rear spring perches Adjustable NG900/9-3
1 x Fog light Replacement Panels
1 x 3 Point Hardware
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Brake Vac pump seals
2 x Replacement V6 Coolant Cap
2 x Limit Strap Coilover Add On Kit
1 x 9-3 /NG900 Grille
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Aluminum Flywheel For NG900/9-3
1 x Machined Control Arm Kit
3 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Steering Rod Bushings NG900/93
1 x Basic Subframe Brace
1 x Fog light 9-3 left 99-00
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x 9-3 ng900 Hood Protection Strip
2 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Rear Camber Shims Kit 6pcs
2 x Sparkplugs 9-3SS
1 x 9-3 / 900 Uprated Front ARB Bushings
4 x Shift Rod Bushings
3 x K&N Filter Service Kit
5 x MTF0063 Manual Gear oil
2 x PPC 3 Volvo Diagnostic System
1 x 9-5 Open Air Prefilter
3 x c900 Performance Brake lines
1 x Upgrade Valve Springs T5 Cars
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x Shifter Alignment Pins (Set 2)
2 x 9-3 99-02,03 CV Antenna Adaptor
1 x Weld Bungs -Taper- Race Only
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
2 x Exhaust manifold Stud Kit
1 x BSR Optiflow Replacement Filter V6 2.8
1 x B207 Coolant Cap
1 x 9-3 SS Akebono Rear Pads
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x 4 Cyl 2.0 Coolant Tank
1 x Floormats BSR 9-3 99-02 900 94-98
1 x BSR Optiflow Intake 4cyl w SAI
1 x Turbo to Downpipe Flange B207
1 x Midpipe 2.8T FWD (2wd)
1 x Cigarette Lighter
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Clear Little Fender Blinkers Factory Saab
1 x Brembo Kit 315mm Hawk HPS Pads
1 x T7 Injector Spacer Kit
1 x Custom Brake Lines RR 300mm Kit
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Rod Bearings only Pauter Rods
1 x Forge Bypass Valve Cobalt/HHR TC
1 x T7 Head Plug NGK
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Map/MAT sensor weld bung
1 x v6 2.8t SAI Delete Kit
$32,139.20
Manufacturer Info
Goodridge
Other products
Share Product
Share via E-Mail