$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Viggen Titanium KeyChain
4 x Saab black Keychain
2 x Moog Ball Joint
1 x Con Rods V6 2.8L 155.8mm
2 x Replacement V6 Coolant Cap
3 x Limit Strap Coilover Add On Kit
2 x 3 Point Hardware
2 x PPC 3 Volvo Diagnostic System
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Head Bolt Washers
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x K&N Filter Service Kit
1 x Shifter Alignment Pins (Set 2)
1 x c900 Performance Brake lines
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Oil Cap GM "HHR"
1 x MTF0063 Manual Gear oil
2 x Basic Subframe Brace
3 x SCNA Christmas Calendar
1 x Aero Clutch Kit 9-5
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
3 x Steering Coupler 9-3 99-02
1 x Replacement Filter for Open air 9-3 T7
2 x 9000 Intercooler ETS
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x Exhaust Clamp Kit
2 x Shift Rod Bushings
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Cat back for Viggen 2.5in
2 x 9-3 /NG900 Grille
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Oil Filter Re-locator
1 x Injectors Green Giant 42lb (set 4)
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Genuine Saab 4cyl Oil Filters
1 x ATF Saab 3309 (Automatic 02->)
1 x 9-3/NG900 Shift Knobs Leather
3 x Clear Little Fender Blinkers Factory Saab
1 x Open Air Intake 9000 93-98
1 x T7 Head Plug NGK
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x 9-3 ng900 Hood Protection Strip
1 x Fuel Line Clip
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Remote Button NG900
2 x Mass Airflow Meter T7
2 x ARP Ring Gear Bolts F25/F35
2 x Exhaust manifold Stud Kit
3 x Rear Engine Mount 4cyl
2 x Crush Sleeve F35 F25
1 x Rear spring perches Adjustable NG900/9-3
1 x Headbolts (New Style)
1 x Direct Ignition T7 Black
1 x Fog light Replacement Panels
1 x 9-5 Shift Knobs Leather
1 x JE Piston Rings 90.0mm 235/205
4 x Head Stud Kit all 4cyl
1 x 9-5 Rear Brake rotor See Description
1 x Air Filter 06 version (All 9-5)
1 x 4340 Connecting Rods B204 B235
2 x Rear Camber Shims Kit 6pcs
3 x ARP Exhaust Manifold Stud kit Stainless
1 x Antenna Plug NG900/9-3 hatchback
1 x Crank Vent Kit #6 T7 4cyl
1 x Aluminum Flywheel For NG900/9-3
1 x Shifter Top Ghost Logo
1 x 9-5 Textile Mats 98-07
1 x Fog light 9-3 Right 99-00
2 x Quaife Differential 9-5 and Viggen (F35)
2 x Slave Cyl
1 x Balance Shaft Tensioner Delete
2 x Steering Rod Bushings NG900/93
2 x 9000 High Performance Brake Line Kit '95-'98
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x Flywheel Twin Disk 7.25in B2xx
1 x Direct Ignition T5 RED
1 x Replacement Hardware Pack 6-Point
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x Downpipe Hardware Kit
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x v6oilcoolplate
1 x Machined Control Arm Kit
1 x Intake Flange B2x4 T5
1 x T7 Injector Spacer Kit
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Viggen Fog Air Intake
1 x Front Camber Adjustment Bolts
2 x Oil Cap 9-3SS V6 "Griffin"
1 x B207 Upper Radiator Coolant T
1 x Oil Cooler Adaptor B2X5
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Griffin logo Shifter Top
1 x 9-3 Rear Ashtray
2 x Viggen Clutch Kit 99-02
1 x Rod Bearings only Pauter Rods
1 x Coreganizer
1 x Rear Brake Pads 9-5 Later Style
1 x Optical Cable Connector (Onstar Delete)
1 x Troll Head Plug
1 x Turbo Conversion Pipe 900 9-3 T5
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Downpipe 2.8T XWD (4wd)
1 x Throttle Body T7
1 x Throttle Bend for T5 94-99
1 x Sparkplugs 9-3SS
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Valve Cover Gasket Set 4cyl
1 x Midpipe 2.8T FWD (2wd)
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Turbo to Downpipe Flange B207
1 x BSR Optiflow Intake 4cyl
$28,535.21
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail