$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
8 x Open Air Intake 9-3 00-02 and Viggen (All T7)
6 x Turbo Conversion Pipe 900 9-3 T5
6 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Oil Cooler Adaptor B2X5
3 x T7 Injector Spacer Kit
3 x Throttle Bend for T5 94-99
2 x Viggen Fog Air Intake
2 x PPC - Upgrade from stage 1 to stage 3
1 x Remote Button NG900
2 x Crush Sleeve F35 F25
2 x Replacement Hardware Pack 6-Point
2 x Exhaust Clamp Kit
1 x Crank Vent Kit #6 T7 4cyl
1 x Genuine Saab 4cyl Oil Filters
3 x Flex Pipe 900 94-98 9-3 99-02
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Direct Ignition T7 Black
1 x Downpipe Hardware Kit
3 x Rear Engine Mount 4cyl
1 x Fuel Line Clip
1 x Mass Airflow Meter T7
2 x Replacement Filter for Open air 9-3 T7
1 x 9-3/NG900 Shift Knobs Leather
1 x Aluminum Flywheel For NG900/9-3
2 x Quaife Differential 9-5 and Viggen (F35)
1 x Flywheel Twin Disk 7.25in B2xx
3 x 20th Viggen logo Shifter Top
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Shifter Alignment Pins (Set 2)
1 x Cat back for Viggen 2.5in
4 x ARP Exhaust Manifold Stud kit Stainless
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Moog Ball Joint
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x 9-5 Shift Knobs Leather
3 x Clear Little Fender Blinkers Factory Saab
1 x Filter 9-5 Cabin Air
4 x T7 3.5 Bar Fuel Pressure Regulator
2 x Bulb Switch Light
2 x Basic Subframe Brace
1 x 9000 High Performance Brake Line Kit '95-'98
3 x MTF0063 Manual Gear oil
1 x 9000 Shifter Bushing Repair Kit
1 x 9000 Intercooler ETS
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Shift Rod Bushings
1 x Head Bolt Washers
1 x Shifter Top Ghost Logo
1 x Griffin logo Shifter Top
1 x c900 Performance Brake lines
2 x Transmission Nut F35 F25
1 x Throttle Body T7
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x BSR Optiflow Intake V6 2.8t
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x 9-5 Intercooler ETS
2 x ARP Ring Gear Bolts F25/F35
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Replacement V6 Coolant Cap
1 x B207 Coolant Cap
1 x Cigarette Lighter
1 x Weld Bungs -Taper- Race Only
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Shifter Mount Kit 93ss
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x B207 Upper Radiator Coolant T
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x v6oilcoolplate
1 x Aero Clutch Kit 9-5
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
$24,582.47
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail