$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x PPC 3 Volvo Diagnostic System
1 x ATF Saab 3309 (Automatic 02->)
1 x Intake Flange B2x4 T5
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Fuel Pressure Regulator 4.0 bar
1 x Injectors Green Giant 42lb (set 4)
1 x Injectors Siemens 80lb 875cc (set 4)
2 x T5 3.0 Bar Map Sensor Adaptor
1 x Injectors Siemens 60lb 630cc (set 4)
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Map/MAT sensor weld bung
2 x Head Bolt Washers
2 x Universal / Special Request
4 x PPC - Upgrade from stage 1 to stage 3
2 x IAT Weld Bung T5/Bosch
1 x AEM Wideband Gauge Kit
1 x Rivetnuts Pair (2pcs)
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x BSR Optiflow Intake 4cyl
1 x BSR 9-5 260Hp 2006-
1 x Shifter Mount Kit 93ss
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Filter 9-5 Cabin Air
1 x Crush Sleeve F35 F25
1 x Head Stud Kit all 4cyl
1 x Direct Ignition T7 Black
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Rear Pedestal Spoiler 9-3 SS
3 x Crank Vent Kit #6 T7 4cyl
1 x Shift Rod Bushings
2 x Headbolts (New Style)
2 x Air Filter 06 version (All 9-5)
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x 9-5 Blend Flap Limit Lever 99-04
2 x Coolant Bypass Valve 9-5
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9-5 Aero Sill Protection
2 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Hood Emblem 9-5 All
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Front Camber Adjustment Bolts
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x T7 Injector Spacer Kit
2 x Drop in Sport Filter 9-5
2 x Fog light Replacement Panels 99-01
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Exhaust manifold Stud Kit
1 x Rear Camber Shims Kit 6pcs
3 x 20th Viggen logo Shifter Top
2 x Clear Little Fender Blinkers Factory Saab
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 9-5 Intercooler ETS
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Floormats BSR 9-5
1 x Coreganizer
4 x Adaptor Harness Handsfree 01-
1 x B207 Upper Radiator Coolant T
1 x V6 Tank Float - SparePart
1 x Sparkplugs 9-3SS
2 x Replacement V6 Coolant Cap
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Optical Cable Connector (Onstar Delete)
1 x 3 Point Hardware
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x 9-5 Shift Knobs Leather
1 x Metal Steering Wheel Buttons
2 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x 9-5 Textile Mats 98-07
2 x 9-3 Rear Ashtray
2 x Transmission Nut F35 F25
1 x Replacement Flywheel Insert NG900/9-3
1 x 9-3 ng900 radio wires
1 x Shifter Top Ghost Logo
1 x Cat back for Viggen 2.5in
1 x Alu Hybrid Flywheel For NG900/9-3
1 x 9-3/NG900 Shift Knobs Leather
1 x Flywheel Twin Disk 7.25in B2xx
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Slave Cyl
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Steering Coupler 9-3 99-02
1 x Exhaust Clamp Kit
1 x Antenna Plug NG900/9-3 hatchback
1 x Fog light 9-3 left 99-00
1 x Fog light 9-3 Right 99-00
1 x T7 Head Plug NGK
1 x Mass Airflow Meter T7
1 x Genuine Saab 4cyl Oil Filters
1 x 9000 High Performance Brake Line Kit '95-'98
1 x Weld Bungs -Taper- Race Only
2 x 9-5 Exhaust Flex Pipe Stainless
1 x Headlight Bulb H7 Longer Life
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Oil Cooler Adaptor B2X5
1 x Steering Rod Bushings NG900/93
1 x Turbo to Downpipe Flange B207
1 x Valve Cover Gasket Set 4cyl
1 x Throttle Body T7
1 x 9-5 Open Air Prefilter
1 x Oil Pressure Switch
1 x Downpipe Hardware Kit
1 x Fuel Line Clip
1 x Fog light Replacement Panels
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
2 x Brake Vac pump seals
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x K&N Filter Service Kit
1 x Throttle Bend for T5 94-99
1 x Shifter Alignment Pins (Set 2)
1 x v6oilcoolplate
1 x Con Rods V6 2.8L 155.8mm
1 x Rear spring perches Adjustable NG900/9-3
1 x Troll Head Plug
$24,742.99
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail