$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
5 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
5 x BSR Optiflow Intake V6 2.8t
2 x InjectorDynamics 725cc For 2.8V6 (Set6)
6 x Midpipe 2.0T 07-11 FWD (2wd)
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 20th Viggen logo Shifter Top
5 x Forge Bypass Valve Cobalt/HHR TC
3 x ShortShift Kit 93ss
1 x Rear Pedestal Spoiler 9-3 SS
1 x SCNA Christmas Calendar
1 x Moog Ball Joint
3 x IAT Weld Bung T5/Bosch
4 x Oil Cap 9-3SS V6 "Ghost"
3 x v6 header flange
1 x BSR Optiflow Intake 4cyl w SAI
3 x Turbo to Downpipe Flange B207
5 x Oil Cap 9-3SS V6 "Griffin"
2 x v6 2.8t SAI Delete Kit
3 x Oil Cap 9-3SS "Ghost"
3 x v6oilcoolplate
1 x Weld Bungs -Taper- Race Only
4 x Shifter Mount Kit Cobalt/ HHR
2 x Intake Flange B2x4 T5
1 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Exhaust manifold Stud Kit
1 x Rear spring perches Adjustable NG900/9-3
2 x Griffin logo Shifter Top
1 x T7 Injector Spacer Kit
2 x Limit Strap Coilover Add On Kit
3 x Midpipe 2.8T XWD (4wd)
1 x Rear Camber Shims Kit 6pcs
1 x Troll Head Plug
1 x Map/MAT sensor weld bung
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Oil Cooler Adaptor B2X5
1 x Shifter Top Ghost Logo
1 x Viggen Fog Air Intake
2 x Head Bolt Washers
1 x Machined Control Arm Kit
2 x Shift Rod Bushings
2 x Open Air Intake 9000 93-98
1 x Throttle Bend for T5 94-99
1 x Torque Mount Insert V6 Manual (XWD and FWD)
3 x Turbo Conversion Pipe 900 9-3 T5
1 x Transmission Nut F35 F25
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Replacement Hardware Pack 6-Point
1 x Steering Rod Bushings NG900/93
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Short Shifter HHR Cobalt F35 F40
1 x Steering Coupler 9-3 99-02
1 x 9-5 Wheel 10-Spoke 16in.
3 x 3 Point Hardware
5 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x 4 Cyl 2.0 Coolant Tank
1 x Shifter Mount Kit 93ss
1 x Goodridge Brake Lines 9-3 SS / SC 03-
3 x Adaptor Harness Handsfree 01-
1 x Floormats BSR 9-3SS/SC
1 x Coreganizer
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
3 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
4 x Headlight Connector Repair Kit 9-3SS 9-5
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x Replacement V6 Coolant Cap
4 x Basic Subframe Brace
3 x Hood Emblem 9-3 SS/sc 03- All
4 x K&N Filter Service Kit
2 x MTF0063 Manual Gear oil
3 x Shifter Alignment Pins (Set 2)
3 x PPC - Upgrade from stage 1 to stage 3
1 x BBS Center Cap for 9-2x RK small caps
4 x B207 Coolant Cap
1 x 9-5 Intercooler ETS
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Metal Steering Wheel Buttons
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x 9-3 Rear Ashtray
3 x Con Rods V6 2.8L 155.8mm
1 x Injectors 175hp Stg3 (Set4)
2 x BSR Optiflow Intake 4cyl
2 x Downpipe 2.8T XWD (4wd)
1 x Downpipe 2.8T FWD (2wd)
3 x Midpipe 2.8T FWD (2wd)
1 x Oil Filter Re-locator
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Replacement Filter for Open air 9-3 T7
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Balance Shaft Tensioner Delete
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9-5 High Performance Brake Line Kit
2 x Universal / Special Request
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Sparkplugs 9-3SS
1 x V6 Tank Float - SparePart
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x 9000 High Performance Brake Line Kit '95-'98
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x Brake Vac pump seals
1 x Optical Cable Connector (Onstar Delete)
1 x Front Camber Adjustment Bolts
$35,194.75
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail