$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
5 x Exhaust manifold Stud Kit
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Rear spring perches Adjustable NG900/9-3
3 x Basic Subframe Brace
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
3 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Rear Camber Shims Kit 6pcs
3 x Steering Coupler 9-3 99-02
2 x Machined Control Arm Kit
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Rod Bearings only Pauter Rods
2 x Clear Little Fender Blinkers Factory Saab
1 x Headbolts (New Style)
1 x T7 Head Plug NGK
1 x Oil Filter Re-locator
1 x Head Stud Kit all 4cyl
2 x SCNA Christmas Calendar
1 x Viggen Titanium KeyChain
1 x Crush Sleeve F35 F25
1 x Rear Engine Mount 4cyl
1 x Direct Ignition T5 RED
1 x Direct Ignition T7 Black
1 x Remote Button NG900
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Fog light 9-3 Right 99-00
1 x Slave Cyl
1 x Replacement Flywheel Insert NG900/9-3
1 x Fog light 9-3 left 99-00
2 x Shifter Top Ghost Logo
1 x 9-3 /NG900 Grille
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
4 x Shift Rod Bushings
1 x 9-5 Intercooler ETS
1 x PPC - Upgrade from stage 1 to stage 3
1 x Floormats BSR 9-5
1 x Adaptor Harness Handsfree 01-
1 x Rivetnuts Pair (2pcs)
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Upgrade Valve Springs T5 Cars
1 x 9-5 Exhaust Flex Pipe Stainless
2 x MTF0063 Manual Gear oil
1 x Oil Cap 9-3SS V6 "Griffin"
2 x Downpipe 2.8T FWD (2wd)
2 x Shifter Alignment Pins (Set 2)
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Short Shifter HHR Cobalt F35 F40
2 x T7 Injector Spacer Kit
1 x Balance Shaft Tensioner Delete
1 x Shifter Mount Kit Cobalt/ HHR
1 x IAT Weld Bung T5/Bosch
1 x Turbo to Downpipe Flange B207
1 x PPC 3 Volvo Diagnostic System
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Custom Brake Lines RR 300mm Kit
1 x ATF Saab 3309 (Automatic 02->)
2 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Throttle Body T7
1 x Turbo Bypass Valve
1 x Griffin logo Shifter Top
1 x Head Bolt Washers
1 x Intake Flange B2x4 T5
1 x Genuine Saab 4cyl Oil Filters
1 x Downpipe Hardware Kit
1 x Rear Brake Pads 9-5 Later Style
1 x Fuel Pressure Regulator 4.0 bar
1 x Filter 9-5 Cabin Air
1 x 9-5 Shift Knobs Leather
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x BSR 9-5 2010-2011 V6 300Hp
1 x 9-3 Rear Ashtray
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Cat back for Viggen 2.5in
1 x Fog light Replacement Panels 99-01
1 x 3 Point Hardware
1 x BSR Optiflow Intake 4cyl
$16,239.59
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail