$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x PPC 3 Volvo Diagnostic System
4 x MTF0063 Manual Gear oil
3 x K&N Filter Service Kit
3 x Replacement V6 Coolant Cap
1 x B207 Coolant Cap
3 x Con Rods V6 2.8L 155.8mm
1 x Saab black Keychain
1 x Viggen Titanium KeyChain
2 x Troll Head Plug
3 x Shifter Alignment Pins (Set 2)
1 x v6 header flange
2 x BSR 9-5 260Hp 2006-
1 x Drop in Sport Filter 9-5
1 x Oil Pressure Switch
1 x Front Camber Adjustment Bolts
2 x Headlight Bulb H7 Longer Life
1 x Brake Vac pump seals
1 x Fog light Replacement Panels 99-01
1 x T5 3.0 Bar Map Sensor Adaptor
1 x 9-5 Shift Knobs Leather
1 x 9-5 Textile Mats 98-07
1 x Filter 9-5 Cabin Air
1 x Transmission Nut F35 F25
1 x Direct Ignition T7 Black
1 x 9-5 Intercooler ETS
1 x Bulb Switch Light
1 x Floormats BSR 9-5
2 x Cabin Vent Fan
2 x Cat Back Exh for 9-5 Aero 04-, All 06-
2 x v6oilcoolplate
1 x Hood Emblem 9-5 All
1 x Exhaust manifold Stud Kit
1 x PPC - Upgrade from stage 1 to stage 3
1 x Downpipe Hardware Kit
2 x Fuel Line Clip
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Coolant Bypass Valve 9-5
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x Air Filter 06 version (All 9-5)
2 x 9-5 Exhaust Flex Pipe Stainless
1 x Cigarette Lighter
3 x Crush Sleeve F35 F25
1 x Rear Camber Shims Kit 6pcs
1 x Headbolts (New Style)
1 x BSR 9-5 3.0T V6 200Hp
2 x T7 Injector Spacer Kit
1 x Moog Ball Joint
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Clear Little Fender Blinkers Factory Saab
2 x Crank Vent Kit #6 T7 4cyl
1 x Flywheel Twin Disk 7.25in B2xx
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Griffin logo Shifter Top
1 x Throttle Bend for T5 94-99
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x BSR Optiflow Intake 4cyl w SAI
1 x 9-3 Rear Ashtray
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Fog light 9-3 Right 99-00
1 x Shifter Top Ghost Logo
1 x 9-3 ng900 Hood Protection Strip
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Downpipe 2.8T XWD (4wd)
2 x ATF Saab 3309 (Automatic 02->)
2 x Genuine Saab 4cyl Oil Filters
2 x Replacement Filter for Open air 9-3 T7
2 x SCNA Christmas Calendar
1 x Head Stud Kit all 4cyl
1 x Rod Bearings only Pauter Rods
1 x Coreganizer
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Shifter Mount Kit 93ss
1 x ShortShift Kit 93ss
1 x Rear spring perches Adjustable NG900/9-3
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Steering Coupler 9-3 99-02
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Mass Airflow Meter T7
2 x Valve Cover Gasket Set 4cyl
1 x T7 Head Plug NGK
1 x Shift Rod Bushings
1 x Throttle Body T7
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Turbo to Downpipe Flange B207
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Injectors 175hp Stg3 (Set4)
2 x Oil Cap 9-3SS "Ghost"
1 x Midpipe 2.8T XWD (4wd)
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Viggen Fog Air Intake
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x 9-5 Aero Sill Protection
1 x B207 Upper Radiator Coolant T
1 x v6 2.8t SAI Delete Kit
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Oil Cap 9-3SS V6 "Griffin"
$17,474.64
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail