$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
6 x 9-3 / 900 Uprated Front ARB Bushings
4 x Rear Camber Shims Kit 6pcs
2 x Rivetnuts Pair (2pcs)
2 x Universal / Special Request
2 x Machined Control Arm Kit
2 x Intake Flange B2x4 T5
1 x Head Bolt Washers
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Map/MAT sensor weld bung
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Injectors Green Giant 42lb (set 4)
3 x SCNA Christmas Calendar
3 x K&N Filter Service Kit
3 x Clear Little Fender Blinkers Factory Saab
1 x c900 Performance Brake lines
1 x Griffin logo Shifter Top
1 x Adaptor Harness Handsfree 01-
1 x T7 Head Plug NGK
3 x B207 Coolant Cap
1 x Replacement Flywheel Insert NG900/9-3
2 x Shift Rod Bushings
1 x Con Rods V6 2.8L 155.8mm
1 x Replacement V6 Coolant Cap
4 x Shifter Top Ghost Logo
1 x Flywheel Twin Disk 7.25in B2xx
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x ARP Ring Gear Bolts F25/F35
1 x Transmission Nut F35 F25
1 x 9-3 /NG900 Grille
2 x Antenna Plug NG900/9-3 hatchback
1 x Fog light 9-3 Right 99-00
1 x Fog light Replacement Panels
2 x Basic Subframe Brace
6 x Steering Rod Bushings NG900/93
1 x 9-3 / 900 Uprated Suspension Bushings Inner
4 x 9-5 Blend Flap Limit Lever 99-04
4 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x 20th Viggen logo Shifter Top
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x 9-5 Shift Knobs Leather
1 x 9-3 ng900 Hood Protection Strip
1 x Air Filter 06 version (All 9-5)
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-5 Textile Mats 98-07
1 x 9-5 Rear Brake rotor See Description
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Hood Emblem 9-5 All
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
2 x Bulb Switch Light
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x Viggen Clutch Kit 99-02
2 x Turbo Bypass Valve
2 x Flex Pipe 900 94-98 9-3 99-02
4 x Downpipe Hardware Kit
3 x Direct Ignition T7 Black
3 x Fuel Line Clip
3 x Genuine Saab 4cyl Oil Filters
3 x Mass Airflow Meter T7
1 x Slave Cyl
1 x 9-5 Aero Sill Protection
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
2 x Cat back for Viggen 2.5in
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
3 x Exhaust manifold Stud Kit
1 x PPC - Upgrade from stage 1 to stage 3
1 x AEM Wideband Gauge Kit
2 x Moog Ball Joint
3 x Shifter Alignment Pins (Set 2)
3 x ATF Saab 3309 (Automatic 02->)
1 x Coolant Bypass Valve 9-5
2 x Headbolts (New Style)
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Cabin Vent Fan
3 x Crank Vent Kit #6 T7 4cyl
1 x 9-3 ng900 radio wires
1 x Brake Vac pump seals
1 x Downpipe 2.8T FWD (2wd)
1 x 9000 Shifter Bushing Repair Kit
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Weld Bungs -Taper- Race Only
1 x Limit Strap Coilover Add On Kit
1 x Replacement Hardware Pack 6-Point
1 x Brembo Brake Kit 315mm 9-3 SS
2 x MTF0063 Manual Gear oil
1 x T7 Injector Spacer Kit
1 x Turbo Conversion Pipe 900 9-3 T5
1 x ShortShift Kit 93ss
1 x IAT Weld Bung T5/Bosch
1 x Steering Coupler 9-3 99-02
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Open Air Intake 9000 93-98
1 x Oil Cooler Adaptor B2X5
1 x Rear spring perches Adjustable NG900/9-3
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x 9-5 Open Air Prefilter
2 x Viggen Front Brake Disk Pair 308mm
1 x Midpipe 2.8T FWD (2wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
2 x 4340 Connecting Rods B204 B235
1 x Remote Button NG900
2 x Crush Sleeve F35 F25
1 x Replacement Filter for Open air 9-3 T7
1 x Rod Bearings only Pauter Rods
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Injectors 175hp Stg3 (Set4)
1 x Cigarette Lighter
1 x Rear Pedestal Spoiler 9-3 SS
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
2 x Rear Engine Mount 4cyl
1 x Oil Pressure Switch
2 x Valve Cover Gasket Set 4cyl
1 x Throttle Body T7
1 x Headlight Bulb H7 Longer Life
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Sparkplugs 9-3SS
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x ARP Exhaust Manifold Stud kit Stainless
$27,355.78
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail