$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
7 x Forge Bypass Valve Cobalt/HHR TC
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x AEM Wideband Gauge Kit
1 x Fuel Pressure Regulator 4.0 bar
1 x Injectors Green Giant 42lb (set 4)
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Rivetnuts Pair (2pcs)
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Moog Ball Joint
1 x Throttle Bend for T5 94-99
1 x Oil Cooler Adaptor B2X5
1 x 9-3 ng900 radio wires
1 x ARP Exhaust Manifold Stud kit Stainless
3 x 20th Viggen logo Shifter Top
1 x Adaptor Harness Handsfree 01-
1 x Mat Set Textile Jet Black 9-5 10-
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Mat Set Textile Shark Grey 9-5 10-
2 x Short Shifter HHR Cobalt F35 F40
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Shifter Top Ghost Logo
2 x Rear Engine Mount 4cyl
1 x Mat Set Textile Parchment 9-5 10-
1 x Replacement Flywheel Insert NG900/9-3
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Slave Cyl
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Storage Tray / Ashtray Kit 9-5 10-
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Flywheel Twin Disk 7.25in B2xx
1 x Aluminum Flywheel For NG900/9-3
1 x Transmission Nut F35 F25
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x T7 Head Plug NGK
1 x Mass Airflow Meter T7
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x Shifter Mount Kit Cobalt/ HHR
1 x Rod Bearings only Pauter Rods
1 x Steering Coupler 9-3 99-02
1 x JE Piston Rings 90.0mm 235/205
1 x Crush Sleeve F35 F25
1 x Replacement Filter for Open air 9-3 T7
1 x Rear spring perches Adjustable NG900/9-3
2 x Exhaust Clamp Kit
1 x Fog light 9-3 left 99-00
1 x Replacement Hardware Pack 6-Point
1 x Basic Subframe Brace
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Limit Strap Coilover Add On Kit
2 x 9-3 ng900 Hood Protection Strip
1 x Direct Ignition T5 RED
2 x Clear Little Fender Blinkers Factory Saab
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Rear Camber Shims Kit 6pcs
1 x Direct Ignition T7 Black
1 x Downpipe Hardware Kit
1 x Crank Vent Kit #6 T7 4cyl
1 x Machined Control Arm Kit
1 x Oil Filter Re-locator
1 x Head Stud Kit all 4cyl
1 x Genuine Saab 4cyl Oil Filters
1 x Headbolts (New Style)
1 x Balance Shaft Tensioner Delete
2 x Antenna Plug NG900/9-3 hatchback
1 x Fuel Line Clip
1 x Remote Button NG900
2 x 9-3 /NG900 Grille
1 x Steering Rod Bushings NG900/93
1 x 4340 Connecting Rods B204 B235
2 x Oil Cap GM "HHR"
1 x Fog light Replacement Panels
1 x Fog light 9-3 Right 99-00
1 x SCNA Christmas Calendar
1 x Air Filter 06 version (All 9-5)
2 x 9-5 Aero Sill Protection
1 x Saab black Keychain
1 x 9-5 Textile Mats 98-07
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Shifter Mount Kit 93ss
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Fog light Replacement Panels 99-01
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x 9000 Intercooler ETS
1 x Griffin logo Shifter Top
1 x Head Bolt Washers
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x ShortShift Kit 93ss
1 x Midpipe 2.8T XWD (4wd)
1 x Front Camber Adjustment Bolts
1 x Viggen Clutch Kit 99-02
1 x 9-5 Exhaust Flex Pipe Stainless
1 x V6 Tank Float - SparePart
1 x Filter 9-5 Cabin Air
1 x Shift Rod Bushings
1 x BSR 9-5 2010-2011 V6 300Hp
$17,752.71
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail