$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x ATF Saab 3309 (Automatic 02->)
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Injectors Siemens 60lb 630cc (set 4)
2 x Fuel Pressure Regulator 4.0 bar
1 x Header Flange Stainless Blended Transition B2x4,B2x5
3 x PPC - Upgrade from stage 1 to stage 3
1 x AEM Wideband Gauge Kit
2 x T7 Head Plug NGK
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x ARP Exhaust Manifold Stud kit Stainless
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x 9-5 Aero Sill Protection
1 x 9-5 Rear Brake rotor See Description
2 x Antenna Plug NG900/9-3 hatchback
2 x 9-5 Shift Knobs Leather
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 9-5 Open Air Prefilter
2 x Griffin logo Shifter Top
3 x 9-5 Blend Flap Limit Lever 99-04
1 x 9-3 Rear Ashtray
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 9-3/NG900 Shift Knobs Leather
1 x Filter 9-5 Cabin Air
2 x Downpipe Hardware Kit
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Limit Strap Coilover Add On Kit
1 x Steering Coupler 9-3 99-02
2 x 9-5 Exhaust Flex Pipe Stainless
1 x Machined Control Arm Kit
3 x Adaptor Harness Handsfree 01-
1 x Oil Pressure Switch
1 x Floormats BSR 9-3 99-02 900 94-98
2 x Fuel Line Clip
1 x 20th Viggen logo Shifter Top
2 x Headlight Bulb H7 Longer Life
1 x Basic Subframe Brace
2 x Steering Rod Bushings NG900/93
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Headbolts (New Style)
1 x Coolant Bypass Valve 9-5
2 x Mass Airflow Meter T7
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Direct Ignition T7 Black
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Genuine Saab 4cyl Oil Filters
1 x Rear Engine Mount 4cyl
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Bulb Switch Light
1 x Direct Ignition T5 RED
1 x 9-3 ng900 Hood Protection Strip
1 x 9-3 /NG900 Grille
1 x Crank Vent Kit #6 T7 4cyl
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Oil Cooler Adaptor B2X5
1 x Floormats BSR 9-5
1 x Fog light Replacement Panels
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Viggen Fog Air Intake
1 x Replacement Filter for Open air 9-3 T7
1 x Front Camber Adjustment Bolts
1 x Remote Button NG900
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Exhaust Clamp Kit
1 x Fog light 9-3 Right 99-00
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Shift Rod Bushings
2 x Clear Little Fender Blinkers Factory Saab
1 x Mat Set Textile Parchment 9-5 10-
1 x Crush Sleeve F35 F25
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Throttle Bend for T5 94-99
1 x BSR 9-5 260Hp 2006-
1 x Fog light 9-3 left 99-00
2 x BSR 9-5 3.0T V6 200Hp
1 x Mat Set Textile Jet Black 9-5 10-
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Aero Clutch Kit 9-5
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Rear Camber Shims Kit 6pcs
1 x Cigarette Lighter
1 x 9-5 Textile Mats 98-07
2 x Replacement Hardware Pack 6-Point
1 x T7 Injector Spacer Kit
1 x Slave Cyl
1 x Mat Set Black Rubber 9-5 10-
1 x Head Stud Kit all 4cyl
1 x Balance Shaft Tensioner Delete
1 x Rod Bearings only Pauter Rods
1 x JE Piston Rings 90.0mm 235/205
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x IAT Weld Bung T5/Bosch
1 x BBS Center Cap for 9-2x RK small caps
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Coreganizer
1 x 9-5 Wheel 10-Spoke 16in.
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x c900 Performance Brake lines
1 x Oil Cap GM "HHR"
1 x Metal Steering Wheel Buttons
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Shifter Mount Kit 93ss
1 x Front Camber Adjustment Bolts
1 x Floormats BSR 9-3SS/SC
2 x ShortShift Kit 93ss
1 x Rear Pedestal Spoiler 9-3 SS
1 x Con Rods V6 2.8L 155.8mm
2 x Sparkplugs 9-3SS
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x Downpipe 2.8T FWD (2wd)
1 x V6 Tank Float - SparePart
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x B207 Upper Radiator Coolant T
1 x B207 Coolant Cap
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
2 x Brake Vac pump seals
1 x Midpipe 2.8T XWD (4wd)
1 x Injectors 175hp Stg3 (Set4)
1 x Optical Cable Connector (Onstar Delete)
1 x Downpipe 2.8T XWD (4wd)
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x 3 Point Hardware
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Midpipe 2.8T FWD (2wd)
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x BSR Optiflow Intake 4cyl w SAI
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Replacement V6 Coolant Cap
1 x BSR Optiflow Intake V6 2.8t
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Viggen Front Brake Disk Pair 308mm
1 x Shifter Top Ghost Logo
1 x Brembo Brake Kit 315mm 9-3 SS
1 x 9000 Shifter Bushing Repair Kit
$28,787.78
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail