$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x PPC 3 Volvo Diagnostic System
1 x Universal / Special Request
1 x Rivetnuts Pair (2pcs)
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Injectors Siemens 80lb 875cc (set 4)
2 x AEM Wideband Gauge Kit
2 x Injectors Green Giant 42lb (set 4)
3 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Saab black Keychain
1 x SCNA Christmas Calendar
4 x B207 Coolant Cap
1 x Short Shifter HHR Cobalt F35 F40
2 x ATF Saab 3309 (Automatic 02->)
4 x MTF0063 Manual Gear oil
2 x Exhaust manifold Stud Kit
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x Steering Coupler 9-3 99-02
2 x 9-5 Aero Sill Protection
1 x 9-3 Rear Ashtray
1 x Griffin logo Shifter Top
2 x JE Piston Rings 90.0mm 235/205
2 x Rod Bearings only Pauter Rods
2 x Headbolts (New Style)
2 x Balance Shaft Tensioner Delete
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x Adaptor Harness Handsfree 01-
2 x Oil Filter Re-locator
1 x 9-3 99-02,03 CV Antenna Adaptor
4 x Head Stud Kit all 4cyl
1 x Replacement Flywheel Insert NG900/9-3
2 x Sport Transmission Mount 9-3/900 (Automatic)
1 x ARP Ring Gear Bolts F25/F35
3 x Shift Rod Bushings
1 x Intake Flange B2x4 T5
1 x Slave Cyl
1 x Quaife Differential 9-5 and Viggen (F35)
1 x 20th Viggen logo Shifter Top
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Shifter Top Ghost Logo
1 x Front Camber Adjustment Bolts
1 x Cat back for Viggen 2.5in
1 x Aluminum Flywheel For NG900/9-3
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x 9000 High Performance Brake Line Kit '95-'98
2 x 9-3 / 900 Uprated Suspension Bushings Inner
4 x Rear Engine Mount 4cyl
1 x Flywheel Twin Disk 7.25in B2xx
2 x Transmission Nut F35 F25
3 x Exhaust Clamp Kit
6 x ARP Exhaust Manifold Stud kit Stainless
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
3 x 9-5 Blend Flap Limit Lever 99-04
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
3 x Genuine Saab 4cyl Oil Filters
2 x Remote Button NG900
2 x 9-3 /NG900 Grille
1 x Fog light 9-3 left 99-00
3 x Crank Vent Kit #6 T7 4cyl
1 x Fog light 9-3 Right 99-00
1 x Replacement Hardware Pack 6-Point
3 x Crush Sleeve F35 F25
2 x Direct Ignition T7 Black
2 x Antenna Plug NG900/9-3 hatchback
2 x Mass Airflow Meter T7
2 x Direct Ignition T5 RED
1 x Fog light Replacement Panels
3 x Downpipe Hardware Kit
4 x Fuel Line Clip
2 x 9-5 Open Air Prefilter
2 x 9-5 Wheel 10-Spoke 16in.
2 x 9-5 Wheel 5-Spoke Twin 17in
2 x Coolant Bypass Valve 9-5
1 x 9000 Shifter Bushing Repair Kit
2 x Air Filter 06 version (All 9-5)
2 x Optical Cable Connector (Onstar Delete)
2 x B207 Upper Radiator Coolant T
1 x 4 Cyl 2.0 Coolant Tank
2 x Downpipe 2.8T FWD (2wd)
1 x Hood Emblem 9-3 SS/sc 03- All
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x Replacement V6 Coolant Cap
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Aero Clutch Kit 9-5
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x PPC - Upgrade from stage 1 to stage 3
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x Sparkplugs 9-3SS
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x 3 Point Hardware
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x 9-3 ng900 Hood Protection Strip
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x Midpipe 2.8T FWD (2wd)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Metal Steering Wheel Buttons
1 x BSR Optiflow Intake V6 2.8t
2 x Downpipe 2.8T XWD (4wd)
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
3 x Injectors 175hp Stg3 (Set4)
1 x 9-3/NG900 Shift Knobs Leather
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x BSR Optiflow Replacement Filter V6 2.8
1 x 9-5 Rear Brake rotor See Description
2 x Coreganizer
1 x BSR Optiflow Intake 4cyl
1 x V6 Tank Float - SparePart
1 x Floormats BSR 9-3SS/SC
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Shift Knobs Leather
2 x Clear Little Fender Blinkers Factory Saab
1 x Rear Pedestal Spoiler 9-3 SS
1 x 9-5 Intercooler ETS
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x Cat Back Exh for 9000 CS, CSE AERO
3 x Steering Rod Bushings NG900/93
1 x Map/MAT sensor weld bung
2 x Moog Ball Joint
2 x T7 Injector Spacer Kit
1 x Upgrade Valve Springs T5 Cars
1 x Con Rods V6 2.8L 155.8mm
2 x Head Bolt Washers
2 x v6oilcoolplate
1 x Viggen Fog Air Intake
1 x Viggen Clutch Kit 99-02
2 x Machined Control Arm Kit
1 x Open Air Intake 9000 93-98
1 x 9-5 Exhaust Flex Pipe Stainless
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Shifter Mount Kit 93ss
2 x Limit Strap Coilover Add On Kit
3 x v6 2.8t SAI Delete Kit
1 x Turbo Bypass Valve
3 x Throttle Body T7
1 x 4340 Connecting Rods B204 B235
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
2 x Oil Pressure Switch
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Viggen Front Brake Disk Pair 308mm
1 x v6 header flange
2 x Rear Rotors PAIR 292mm Plain (Code: BB)
1 x 9-3 SS Akebono Rear Pads
1 x Midpipe 2.8T XWD (4wd)
1 x Brake Vac pump seals
1 x Turbo to Downpipe Flange B207
1 x 9-3 ng900 radio wires
1 x Rear Brake Pads 9-5 Later Style
1 x Troll Head Plug
2 x Basic Subframe Brace
1 x Headlight Bulb H7 Longer Life
1 x Valve Cover Gasket Set 4cyl
1 x Cabin Vent Fan
1 x Filter 9-5 Cabin Air
1 x Cigarette Lighter
2 x Oil Cap 9-3SS V6 "Ghost"
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Hood Emblem 9-5 All
1 x Oil Cap 9-3SS "Ghost"
1 x Weld Bungs -Taper- Race Only
$42,593.27
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail