$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x 3 Point Hardware
4 x IAT Weld Bung T5/Bosch
1 x Oil Cap 9-3SS "Ghost"
3 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x PPC 3 Volvo Diagnostic System
2 x B207 Coolant Cap
1 x SCNA Christmas Calendar
1 x Con Rods V6 2.8L 155.8mm
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x c900 Performance Brake lines
4 x Clear Little Fender Blinkers Factory Saab
2 x V6 Tank Float - SparePart
2 x PPC - Upgrade from stage 1 to stage 3
2 x T5 3.0 Bar Map Sensor Adaptor
1 x Injectors Siemens 60lb 630cc (set 4)
2 x Injectors Siemens 80lb 875cc (set 4)
3 x Universal / Special Request
2 x Injectors Green Giant 42lb (set 4)
2 x Intake Flange B2x4 T5
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Fuel Pressure Regulator 4.0 bar
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Rivetnuts Pair (2pcs)
1 x Map/MAT sensor weld bung
2 x Head Bolt Washers
2 x Transmission Nut F35 F25
2 x Front Camber Adjustment Bolts
2 x Shifter Mount Kit 93ss
1 x Fog light Replacement Panels 99-01
1 x 9-5 Textile Mats 98-07
2 x Direct Ignition T7 Black
1 x Metal Steering Wheel Buttons
1 x Ignition Coil 9-3SS 2.8t and 2.8T
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Downpipe Hardware Kit
1 x Antenna Plug NG900/9-3 hatchback
4 x Midpipe 2.8T FWD (2wd)
1 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x Fuel Line Clip
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x Adaptor Harness Handsfree 01-
1 x 9-5 Open Air Prefilter
3 x Crank Vent Kit #6 T7 4cyl
1 x BSR Optiflow Intake 4cyl w SAI
1 x Downpipe 2.8T XWD (4wd)
2 x B207 Upper Radiator Coolant T
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x BSR 9-5 3.0T V6 200Hp
1 x Coolant Bypass Valve 9-5
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Cat back for Viggen 2.5in
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Mat Set Black Rubber 9-5 10-
1 x Rod Bearings only Pauter Rods
1 x Oil Filter Re-locator
1 x Balance Shaft Tensioner Delete
2 x 9-3 ng900 radio wires
2 x Aluminum Flywheel For NG900/9-3
3 x Shift Rod Bushings
1 x Steering Coupler 9-3 99-02
1 x Shifter Top Ghost Logo
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Fog light Replacement Panels
1 x 9-3 /NG900 Grille
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Replacement Flywheel Insert NG900/9-3
1 x Slave Cyl
1 x Fog light 9-3 left 99-00
1 x Fog light 9-3 Right 99-00
2 x Rear Camber Shims Kit 6pcs
2 x Rear Engine Mount 4cyl
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Machined Control Arm Kit
2 x Flywheel Twin Disk 7.25in B2xx
2 x Quaife Differential 9-5 and Viggen (F35)
1 x Basic Subframe Brace
1 x 9-3 ng900 Hood Protection Strip
1 x ARP Ring Gear Bolts F25/F35
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Steering Rod Bushings NG900/93
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Rear spring perches Adjustable NG900/9-3
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Replacement Hardware Pack 6-Point
1 x 9000 Intercooler ETS
1 x Direct Ignition T5 RED
2 x Crush Sleeve F35 F25
2 x Exhaust Clamp Kit
1 x Replacement Filter for Open air 9-3 T7
1 x Remote Button NG900
1 x Genuine Saab 4cyl Oil Filters
1 x Shifter Mount Kit Cobalt/ HHR
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Moog Ball Joint
1 x Griffin logo Shifter Top
1 x 9-5 Aero Sill Protection
2 x 20th Viggen logo Shifter Top
1 x Oil Cap GM "HHR"
3 x Midpipe 2.0T 07-11 FWD (2wd)
1 x BBS Center Cap for 9-2x RK small caps
1 x BSR Optiflow Intake 4cyl
1 x MTF0063 Manual Gear oil
2 x v6oilcoolplate
1 x Air Filter 06 version (All 9-5)
1 x Throttle Body T7
1 x Sparkplugs 9-3SS
1 x Hood Emblem 9-5 All
1 x T7 Injector Spacer Kit
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Headlight Bulb H7 Longer Life
1 x Headbolts (New Style)
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Mat Set Textile Parchment 9-5 10-
1 x Limit Strap Coilover Add On Kit
1 x Turbo Bypass Valve
1 x Mat Set Textile Jet Black 9-5 10-
2 x BSR 9-5 2010-2011 V6 300Hp
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Saab black Keychain
1 x Custom Brake Lines RR 300mm Kit
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
3 x Short Shifter HHR Cobalt F35 F40
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x 9-5 Rear Brake rotor See Description
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x 9-5 High Performance Brake Line Kit
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Brembo Kit 315mm Hawk HPS Pads
$32,487.75
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail