$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x SCNA Christmas Calendar
2 x T5 3.0 Bar Map Sensor Adaptor
1 x Replacement V6 Coolant Cap
1 x B207 Coolant Cap
1 x 3 Point Hardware
1 x IAT Weld Bung T5/Bosch
2 x Rivetnuts Pair (2pcs)
3 x Moog Ball Joint
2 x 9000 Shifter Bushing Repair Kit
2 x Map/MAT sensor weld bung
2 x Intake Flange B2x4 T5
1 x Con Rods V6 2.8L 155.8mm
1 x Injectors Green Giant 42lb (set 4)
1 x Universal / Special Request
2 x Injectors Siemens 60lb 630cc (set 4)
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x AEM Wideband Gauge Kit
3 x PPC - Upgrade from stage 1 to stage 3
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Oil Cap GM "HHR"
1 x PPC 3 Volvo Diagnostic System
2 x Short Shifter HHR Cobalt F35 F40
2 x Forge Bypass Valve Cobalt/HHR TC
1 x T7 Head Plug NGK
2 x 9-5 Aero Sill Protection
1 x Clear Little Fender Blinkers Factory Saab
1 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Weld Bungs -Taper- Race Only
3 x Head Bolt Washers
1 x Rear Camber Shims Kit 6pcs
1 x Brake Vac pump seals
1 x v6 header flange
1 x 9-3 ng900 radio wires
2 x Saab black Keychain
2 x 9-5 Exhaust Flex Pipe Stainless
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Aluminum Flywheel For NG900/9-3
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Headbolts (New Style)
1 x T7 Injector Spacer Kit
2 x Downpipe Hardware Kit
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x B207 Upper Radiator Coolant T
1 x Steering Coupler 9-3 99-02
1 x Fog light 9-3 Right 99-00
2 x Direct Ignition T7 Black
1 x Crank Vent Kit #6 T7 4cyl
1 x Exhaust Clamp Kit
1 x Fog light Replacement Panels
1 x ARP Ring Gear Bolts F25/F35
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x 4340 Connecting Rods B204 B235
1 x Head Stud Kit all 4cyl
1 x Machined Control Arm Kit
2 x 9-5 Shift Knobs Leather
2 x Aero Clutch Kit 9-5
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x MTF0063 Manual Gear oil
1 x Shifter Alignment Pins (Set 2)
1 x K&N Filter Service Kit
1 x Shift Rod Bushings
1 x Air Filter 06 version (All 9-5)
1 x 9-3 ng900 Hood Protection Strip
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Textile Mats 98-07
2 x Genuine Saab 4cyl Oil Filters
1 x 9-3 /NG900 Grille
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3/NG900 Shift Knobs Leather
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-5 Rear Brake rotor See Description
1 x ATF Saab 3309 (Automatic 02->)
1 x 9-5 Open Air Prefilter
1 x Crush Sleeve F35 F25
1 x Headlight Bulb H7 Longer Life
1 x 9-3 Rear Ashtray
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
$13,874.58
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail