$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Shifter Alignment Pins (Set 2)
1 x K&N Filter Service Kit
2 x MTF0063 Manual Gear oil
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Short Shifter HHR Cobalt F35 F40
1 x Oil Cap GM "HHR"
1 x Shifter Mount Kit Cobalt/ HHR
2 x IAT Weld Bung T5/Bosch
1 x Universal / Special Request
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Replacement V6 Coolant Cap
1 x Con Rods V6 2.8L 155.8mm
1 x T7 Head Plug NGK
1 x 9000 Shifter Bushing Repair Kit
1 x B207 Coolant Cap
1 x Troll Head Plug
1 x Oil Filter Re-locator
2 x SCNA Christmas Calendar
1 x Head Stud Kit all 4cyl
1 x Aluminum Flywheel For NG900/9-3
1 x Slave Cyl
2 x Flywheel Twin Disk 7.25in B2xx
1 x Shift Rod Bushings
3 x Alu Hybrid Flywheel For NG900/9-3
3 x PPC - Upgrade from stage 1 to stage 3
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Exhaust manifold Stud Kit
2 x Exhaust Clamp Kit
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Quaife Differential 9-5 and Viggen (F35)
3 x Rear Engine Mount 4cyl
1 x Replacement Flywheel Insert NG900/9-3
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Oil Cooler Adaptor B2X5
2 x Rear Camber Shims Kit 6pcs
2 x 20th Viggen logo Shifter Top
2 x T7 3.5 Bar Fuel Pressure Regulator
2 x Downpipe Hardware Kit
1 x T7 Injector Spacer Kit
2 x Direct Ignition T5 RED
2 x Mass Airflow Meter T7
1 x 9-3 ng900 radio wires
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Turbo Conversion Pipe 900 9-3 T5
2 x Replacement Filter for Open air 9-3 T7
2 x Griffin logo Shifter Top
2 x Remote Button NG900
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Throttle Bend for T5 94-99
2 x 9-3/NG900 Shift Knobs Leather
2 x Steering Coupler 9-3 99-02
1 x Viggen Fog Air Intake
1 x Limit Strap Coilover Add On Kit
1 x Steering Rod Bushings NG900/93
2 x Fuel Line Clip
1 x Direct Ignition T7 Black
1 x Replacement Hardware Pack 6-Point
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-3 Rear Ashtray
2 x Crank Vent Kit #6 T7 4cyl
1 x Adaptor Harness Handsfree 01-
2 x Rear spring perches Adjustable NG900/9-3
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Saab black Keychain
1 x Basic Subframe Brace
1 x Crush Sleeve F35 F25
2 x Genuine Saab 4cyl Oil Filters
1 x Coreganizer
2 x Antenna Plug NG900/9-3 hatchback
3 x Clear Little Fender Blinkers Factory Saab
3 x 9-3 /NG900 Grille
2 x Fog light 9-3 Right 99-00
1 x Fog light Replacement Panels
3 x 9-3 ng900 Hood Protection Strip
2 x Fog light 9-3 left 99-00
2 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Optical Cable Connector (Onstar Delete)
1 x Fog light Replacement Panels 99-01
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x 9-5 Shift Knobs Leather
1 x ShortShift Kit 93ss
2 x Cigarette Lighter
1 x Metal Steering Wheel Buttons
1 x Headbolts (New Style)
3 x 9-5 Aero Sill Protection
2 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-5 Wheel 10-Spoke 16in.
1 x Aero Clutch Kit 9-5
1 x 9-5 Textile Mats 98-07
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Rear Brake rotor See Description
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Air Filter 06 version (All 9-5)
2 x ATF Saab 3309 (Automatic 02->)
1 x v6oilcoolplate
1 x ARP Ring Gear Bolts F25/F35
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Viggen Clutch Kit 99-02
1 x Open Air Intake 9000 93-98
1 x Intake Flange B2x4 T5
2 x Machined Control Arm Kit
2 x Turbo Bypass Valve
1 x Downpipe 2.8T FWD (2wd)
1 x Brake Vac pump seals
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Headlight Bulb H7 Longer Life
1 x Sparkplugs 9-3SS
1 x Rear Pedestal Spoiler 9-3 SS
2 x Viggen Front Brake Disk Pair 308mm
1 x Map/MAT sensor weld bung
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x AEM Wideband Gauge Kit
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Oil Pressure Switch
1 x Midpipe 2.8T FWD (2wd)
1 x Rear Brake Pads 9-5 Later Style
$27,764.50
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail