$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Map/MAT sensor weld bung
1 x Fuel Pressure Regulator 4.0 bar
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x ARP Ring Gear Bolts F25/F35
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Exhaust manifold Stud Kit
1 x Limit Strap Coilover Add On Kit
1 x Replacement Flywheel Insert NG900/9-3
1 x Machined Control Arm Kit
2 x Shift Rod Bushings
1 x Cat back for Viggen 2.5in
1 x Slave Cyl
1 x Transmission Nut F35 F25
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Oil Filter Re-locator
1 x Fog light 9-3 Right 99-00
1 x JE Piston Rings 90.0mm 235/205
1 x Crank Vent Kit #6 T7 4cyl
2 x Crush Sleeve F35 F25
1 x 4340 Connecting Rods B204 B235
1 x Headbolts (New Style)
1 x Direct Ignition T7 Black
1 x 9-3 /NG900 Grille
1 x Fog light 9-3 left 99-00
1 x Antenna Plug NG900/9-3 hatchback
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Direct Ignition T5 RED
2 x Replacement Hardware Pack 6-Point
1 x Genuine Saab 4cyl Oil Filters
1 x Rod Bearings only Pauter Rods
1 x Remote Button NG900
1 x Fog light Replacement Panels
1 x Rear Engine Mount 4cyl
2 x Exhaust Clamp Kit
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Throttle Bend for T5 94-99
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 20th Viggen logo Shifter Top
2 x Coreganizer
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Viggen Fog Air Intake
1 x T7 Injector Spacer Kit
1 x 9-3 ng900 radio wires
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Oil Cooler Adaptor B2X5
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x PPC - Upgrade from stage 1 to stage 3
1 x 9-3 Rear Ashtray
2 x Adaptor Harness Handsfree 01-
1 x 9-3/NG900 Shift Knobs Leather
1 x Griffin logo Shifter Top
1 x 9-3 / 900 Uprated Front ARB Bushings
3 x Oil Cap GM "HHR"
1 x Short Shifter HHR Cobalt F35 F40
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Shifter Mount Kit Cobalt/ HHR
1 x MTF0063 Manual Gear oil
1 x Shifter Mount Kit 93ss
1 x Front Camber Adjustment Bolts
1 x Oil Cap 9-3SS V6 "Ghost"
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x ShortShift Kit 93ss
1 x Rear Pedestal Spoiler 9-3 SS
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Optical Cable Connector (Onstar Delete)
1 x BSR Optiflow Intake 4cyl
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Injectors 175hp Stg3 (Set4)
1 x Downpipe 2.8T XWD (4wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x BSR Optiflow Intake V6 2.8t
1 x Midpipe 2.8T XWD (4wd)
1 x Midpipe 2.8T FWD (2wd)
1 x BSR Optiflow Intake 4cyl w SAI
1 x Brake Vac pump seals
1 x Sparkplugs 9-3SS
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x B207 Upper Radiator Coolant T
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Floormats BSR 9-3SS/SC
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x B207 Coolant Cap
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x Con Rods V6 2.8L 155.8mm
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Downpipe 2.8T FWD (2wd)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Metal Steering Wheel Buttons
1 x Replacement V6 Coolant Cap
1 x V6 Tank Float - SparePart
1 x T7 Head Plug NGK
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Throttle Body T7
1 x Upgrade Valve Springs T5 Cars
$21,208.61
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail