$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
5 x Clear Little Fender Blinkers Factory Saab
1 x c900 Performance Brake lines
1 x Limit Strap Coilover Add On Kit
1 x Con Rods V6 2.8L 155.8mm
1 x 9000 Shifter Bushing Repair Kit
1 x T7 Head Plug NGK
3 x SCNA Christmas Calendar
2 x Troll Head Plug
2 x 9-5 Aero Sill Protection
1 x Flex Pipe 900 94-98 9-3 99-02
2 x ARP Ring Gear Bolts F25/F35
1 x Coreganizer
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x 9-3 ng900 radio wires
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Shifter Top Ghost Logo
1 x Transmission Nut F35 F25
2 x Exhaust Clamp Kit
1 x Remote Button NG900
1 x Aluminum Flywheel For NG900/9-3
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Replacement Filter for Open air 9-3 T7
2 x Direct Ignition T5 RED
2 x 20th Viggen logo Shifter Top
3 x Shift Rod Bushings
1 x 9-3 /NG900 Grille
1 x Crush Sleeve F35 F25
1 x Genuine Saab 4cyl Oil Filters
2 x Rear Engine Mount 4cyl
1 x Antenna Plug NG900/9-3 hatchback
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Direct Ignition T7 Black
1 x Fuel Line Clip
1 x Replacement Flywheel Insert NG900/9-3
2 x Downpipe Hardware Kit
3 x Griffin logo Shifter Top
1 x 9-3/NG900 Shift Knobs Leather
1 x 9-3 ng900 Hood Protection Strip
2 x 9-3 Rear Ashtray
2 x Fog light Replacement Panels
1 x Adaptor Harness Handsfree 01-
1 x Slave Cyl
1 x Throttle Bend for T5 94-99
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x Rear spring perches Adjustable NG900/9-3
2 x Oil Filter Re-locator
1 x Headbolts (New Style)
1 x Basic Subframe Brace
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Moog Ball Joint
2 x Head Stud Kit all 4cyl
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
4 x Oil Cap 9-3SS V6 "Ghost"
2 x Mat Set Textile Shark Grey 9-5 10-
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x BSR 9-5 2010-2011 V6 300Hp
3 x Oil Cap 9-3SS V6 "Griffin"
2 x 9-5 Wheel 5-Spoke Twin 17in
2 x K&N Filter Service Kit
2 x Mat Set Black Rubber 9-5 10-
2 x Mat Set Textile Jet Black 9-5 10-
2 x Mat Set Textile Parchment 9-5 10-
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 3 Point Hardware
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x B207 Upper Radiator Coolant T
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Steering Coupler 9-3 99-02
2 x V6 Tank Float - SparePart
1 x Forge Bypass Valve Cobalt/HHR TC
1 x BSR 9-5 260Hp 2006-
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
2 x BSR Optiflow Intake 4cyl
1 x Oil Cooler Adaptor B2X5
1 x PPC - Upgrade from stage 1 to stage 3
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Turbo Bypass Valve
1 x Oil Cap GM "HHR"
1 x Shifter Alignment Pins (Set 2)
2 x Turbo Conversion Pipe 900 9-3 T5
1 x Balance Shaft Tensioner Delete
2 x 9-5 Blend Flap Limit Lever 99-04
2 x Head Bolt Washers
1 x Replacement V6 Coolant Cap
1 x Filter 9-5 Cabin Air
1 x Map/MAT sensor weld bung
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Shifter Mount Kit 93ss
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x T7 Injector Spacer Kit
1 x Replacement Hardware Pack 6-Point
1 x Rear Camber Shims Kit 6pcs
1 x Open Air Intake 9000 93-98
1 x Oil Cap 9-3SS "Ghost"
1 x Fog light Replacement Panels 99-01
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Turbo to Downpipe Flange B207
1 x IAT Weld Bung T5/Bosch
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Downpipe 2.8T FWD (2wd)
1 x Downpipe 2.8T XWD (4wd)
1 x B207 Coolant Cap
1 x v6oilcoolplate
1 x ShortShift Kit 93ss
1 x Intake Flange B2x4 T5
1 x Shifter Mount Kit Cobalt/ HHR
1 x Fuel Pressure Regulator 4.0 bar
1 x Front Camber Adjustment Bolts
$19,312.08
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail