$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Oil Cap GM "HHR"
2 x Shifter Mount Kit Cobalt/ HHR
3 x IAT Weld Bung T5/Bosch
3 x Intake Flange B2x4 T5
3 x T5 3.0 Bar Map Sensor Adaptor
3 x Fuel Pressure Regulator 4.0 bar
3 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Clear Little Fender Blinkers Factory Saab
1 x Replacement V6 Coolant Cap
1 x T7 Head Plug NGK
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x SCNA Christmas Calendar
3 x Weld Bungs -Taper- Race Only
2 x Moog Ball Joint
3 x PPC - Upgrade from stage 1 to stage 3
2 x Injectors Siemens 60lb 630cc (set 4)
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Head Bolt Washers
1 x Injectors Green Giant 42lb (set 4)
2 x Universal / Special Request
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Rivetnuts Pair (2pcs)
2 x Downpipe Hardware Kit
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x BSR 9-5 3.0T V6 200Hp
1 x Mat Set Textile Parchment 9-5 10-
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Aero Clutch Kit 9-5
1 x Shift Rod Bushings
1 x Air Filter 06 version (All 9-5)
2 x Filter 9-5 Cabin Air
1 x Crank Vent Kit #6 T7 4cyl
1 x Mat Set Textile Jet Black 9-5 10-
1 x Mat Set Textile Shark Grey 9-5 10-
2 x Headlight Bulb H7 Longer Life
1 x Front Camber Adjustment Bolts
1 x 9-5 Aero Sill Protection
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
2 x Coolant Bypass Valve 9-5
1 x Cigarette Lighter
1 x BSR 9-5 2010-2011 V6 300Hp
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Forge Bypass Valve Cobalt/HHR TC
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Throttle Bend for T5 94-99
1 x 9-3/NG900 Shift Knobs Leather
1 x Flywheel Twin Disk 7.25in B2xx
1 x Viggen Fog Air Intake
1 x Replacement Hardware Pack 6-Point
1 x Oil Filter Re-locator
1 x Oil Cooler Adaptor B2X5
1 x 9000 High Performance Brake Line Kit '95-'98
2 x Exhaust manifold Stud Kit
2 x T7 Injector Spacer Kit
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Cat back for Viggen 2.5in
1 x 9-5 High Performance Brake Line Kit
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x 3 Point Hardware
1 x Saab black Keychain
1 x Fog light Replacement Panels 99-01
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x BSR 9-5 260Hp 2006-
1 x Crush Sleeve F35 F25
1 x 9-5 Open Air Prefilter
1 x Genuine Saab 4cyl Oil Filters
1 x Fuel Line Clip
1 x Mass Airflow Meter T7
1 x Rear spring perches Adjustable NG900/9-3
1 x Steering Coupler 9-3 99-02
$13,490.73
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail