$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x 3 Point Hardware
4 x Moog Ball Joint
1 x Limit Strap Coilover Add On Kit
2 x PPC 3 Volvo Diagnostic System
1 x c900 Performance Brake lines
2 x MTF0063 Manual Gear oil
1 x K&N Filter Service Kit
1 x ATF Saab 3309 (Automatic 02->)
4 x IAT Weld Bung T5/Bosch
1 x Universal / Special Request
2 x Injectors Green Giant 42lb (set 4)
5 x PPC - Upgrade from stage 1 to stage 3
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Map/MAT sensor weld bung
1 x Rivetnuts Pair (2pcs)
2 x T5 3.0 Bar Map Sensor Adaptor
2 x Intake Flange B2x4 T5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Fuel Pressure Regulator 4.0 bar
2 x 9-5 Aero Sill Protection
1 x 9-5 Textile Mats 98-07
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Oil Cooler Adaptor B2X5
3 x Genuine Saab 4cyl Oil Filters
1 x Cigarette Lighter
2 x Oil Cap 9-3SS "Ghost"
1 x Rear Camber Shims Kit 6pcs
2 x Front Camber Adjustment Bolts
1 x v6 header flange
1 x Direct Ignition T7 Black
2 x Crush Sleeve F35 F25
2 x Brake Vac pump seals
1 x Oil Pressure Switch
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
2 x 9-5 Open Air Prefilter
3 x Adaptor Harness Handsfree 01-
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Oil Cap GM "HHR"
2 x Headbolts (New Style)
1 x Drop in Sport Filter 9-5
1 x Machined Control Arm Kit
1 x 9-5 Exhaust Flex Pipe Stainless
1 x v6oilcoolplate
1 x Headlight Bulb H7 Longer Life
2 x 20th Viggen logo Shifter Top
4 x B207 Upper Radiator Coolant T
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Alu Hybrid Flywheel For NG900/9-3
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Oil Filter Re-locator
2 x Oil Cap 9-3SS V6 "Griffin"
2 x T7 3.5 Bar Fuel Pressure Regulator
3 x Shift Rod Bushings
2 x Oil Cap 9-3SS V6 "Ghost"
1 x Crank Vent Kit #6 T7 4cyl
2 x Head Bolt Washers
2 x Downpipe Hardware Kit
2 x Steering Coupler 9-3 99-02
2 x Filter 9-5 Cabin Air
1 x Fuel Line Clip
2 x Coolant Bypass Valve 9-5
1 x Mass Airflow Meter T7
2 x T7 Injector Spacer Kit
1 x Bulb Switch Light
1 x Head Stud Kit all 4cyl
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Forge Bypass Valve Cobalt/HHR TC
1 x Hood Emblem 9-5 All
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Slave Cyl
1 x V6 Tank Float - SparePart
1 x 9-3 ng900 radio wires
1 x Aero Clutch Kit 9-5
1 x Metal Steering Wheel Buttons
2 x Downpipe 2.8T FWD (2wd)
1 x Midpipe 2.8T XWD (4wd)
2 x BSR Optiflow Intake V6 2.8t
2 x Downpipe 2.8T XWD (4wd)
2 x Coreganizer
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
2 x Injectors 175hp Stg3 (Set4)
1 x JE Piston Rings 90.0mm 235/205
1 x Balance Shaft Tensioner Delete
1 x Throttle Bend for T5 94-99
2 x Fog light 9-3 left 99-00
2 x Basic Subframe Brace
1 x Rear spring perches Adjustable NG900/9-3
1 x Open Air Intake 9000 93-98
1 x 9000 Shifter Bushing Repair Kit
1 x 9000 Intercooler ETS
1 x 9000 High Performance Brake Line Kit '95-'98
1 x Floormats BSR 9-3SS/SC
5 x SCNA Christmas Calendar
2 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Rear Pedestal Spoiler 9-3 SS
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Midpipe 2.8T FWD (2wd)
2 x BSR Optiflow Intake 4cyl w SAI
1 x Saab black Keychain
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Con Rods V6 2.8L 155.8mm
2 x BSR Optiflow Intake 4cyl
1 x Shifter Mount Kit 93ss
3 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Sparkplugs 9-3SS
1 x Optical Cable Connector (Onstar Delete)
1 x Headlight Connector Repair Kit 9-3SS 9-5
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Replacement V6 Coolant Cap
1 x Rod Bearings only Pauter Rods
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
2 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x Front Camber Adjustment Bolts
1 x ShortShift Kit 93ss
3 x 9-3 /NG900 Grille
1 x Weld Bungs -Taper- Race Only
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x 9-5 High Performance Brake Line Kit
1 x Rear Engine Mount 4cyl
2 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Rear Brake rotor See Description
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Brembo Kit 315mm Hawk HPS Pads
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Exhaust manifold Stud Kit
1 x Rear Brake Pads 9-3 SS
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x 9-3 Rear Ashtray
1 x v6 2.8t SAI Delete Kit
1 x Fog light Replacement Panels 99-01
1 x Fog light Replacement Panels
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x 9-3 ng900 Hood Protection Strip
$31,585.42
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail