$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x PPC 3 Volvo Diagnostic System
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
3 x AEM Wideband Gauge Kit
4 x Forge Bypass Valve Cobalt/HHR TC
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
3 x Injectors Siemens 60lb 630cc (set 4)
2 x T5 3.0 Bar Map Sensor Adaptor
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Replacement V6 Coolant Cap
2 x Limit Strap Coilover Add On Kit
1 x Troll Head Plug
2 x 9000 Shifter Bushing Repair Kit
3 x B207 Coolant Cap
2 x SCNA Christmas Calendar
1 x T7 Head Plug NGK
2 x Con Rods V6 2.8L 155.8mm
1 x K&N Filter Service Kit
1 x Shifter Alignment Pins (Set 2)
2 x ATF Saab 3309 (Automatic 02->)
1 x Downpipe 2.8T FWD (2wd)
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Midpipe 2.8T FWD (2wd)
1 x Cabin Vent Fan
3 x Weld Bungs -Taper- Race Only
1 x Mass Airflow Meter T7
1 x Headlight Bulb H7 Longer Life
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Slave Cyl
2 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x BSR 9-5 260Hp 2006-
3 x ARP Exhaust Manifold Stud kit Stainless
1 x BSR 9-5 3.0T V6 200Hp
2 x T7 Injector Spacer Kit
1 x T7 3.5 Bar Fuel Pressure Regulator
3 x Rivetnuts Pair (2pcs)
3 x Rear Camber Shims Kit 6pcs
1 x Front Camber Adjustment Bolts
2 x Head Stud Kit all 4cyl
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Hood Emblem 9-5 All
1 x Bulb Switch Light
1 x 9-5 Aero Sill Protection
2 x Floormats BSR 9-5
1 x 9-5 Textile Mats 98-07
4 x Clear Little Fender Blinkers Factory Saab
1 x Adaptor Harness Handsfree 01-
1 x 9-5 Shift Knobs Leather
3 x Shift Rod Bushings
1 x Exhaust manifold Stud Kit
1 x Oil Cap 9-3SS V6 "Ghost"
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Machined Control Arm Kit
1 x Steering Coupler 9-3 99-02
2 x Rear spring perches Adjustable NG900/9-3
1 x Oil Filter Re-locator
1 x Flywheel Twin Disk 7.25in B2xx
1 x BSR Optiflow Intake 4cyl w SAI
1 x Metal Steering Wheel Buttons
1 x Steering Rod Bushings NG900/93
1 x Genuine Saab 4cyl Oil Filters
1 x Coolant Bypass Valve 9-5
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x MTF0063 Manual Gear oil
1 x 9000 High Performance Brake Line Kit '95-'98
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x PPC - Upgrade from stage 1 to stage 3
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Drop in Sport Filter 9-5
1 x 9-5 High Performance Brake Line Kit
1 x Head Bolt Washers
2 x Map/MAT sensor weld bung
1 x Aero Clutch Kit 9-5
1 x Fuel Pressure Regulator 4.0 bar
2 x Injectors Green Giant 42lb (set 4)
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Intake Flange B2x4 T5
1 x Universal / Special Request
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Moog Ball Joint
1 x Cigarette Lighter
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Custom Brake Lines RR 300mm Kit
1 x Rear Pedestal Spoiler 9-3 SS
1 x 3 Point Hardware
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x 9000 Intercooler ETS
1 x Open Air Intake 9000 93-98
1 x Crush Sleeve F35 F25
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x BSR Optiflow Intake 4cyl
1 x 9-3 Rear Ashtray
1 x Fog light Replacement Panels 99-01
1 x Optical Cable Connector (Onstar Delete)
1 x ARP Ring Gear Bolts F25/F35
1 x Front Camber Adjustment Bolts
$21,128.22
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail