$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x PPC 3 Volvo Diagnostic System
1 x Short Shifter HHR Cobalt F35 F40
1 x AEM Wideband Gauge Kit
1 x Map/MAT sensor weld bung
2 x Injectors Siemens 60lb 630cc (set 4)
1 x Rivetnuts Pair (2pcs)
1 x Intake Flange B2x4 T5
1 x T5 3.0 Bar Map Sensor Adaptor
3 x IAT Weld Bung T5/Bosch
1 x Universal / Special Request
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Injectors Siemens 80lb 875cc (set 4)
1 x Header Flange Stainless Blended Transition B2x4,B2x5
3 x PPC - Upgrade from stage 1 to stage 3
1 x Fuel Pressure Regulator 4.0 bar
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Head Bolt Washers
1 x Moog Ball Joint
2 x MTF0063 Manual Gear oil
2 x Shifter Alignment Pins (Set 2)
1 x K&N Filter Service Kit
2 x Limit Strap Coilover Add On Kit
2 x T7 Head Plug NGK
1 x Replacement V6 Coolant Cap
1 x Headbolts (New Style)
2 x Fog light Replacement Panels
2 x Floormats BSR 9-3SS/SC
3 x Flex Pipe 900 94-98 9-3 99-02
1 x Cat back for Viggen 2.5in
3 x Coreganizer
2 x Direct Ignition T7 Black
3 x Exhaust Clamp Kit
2 x Sparkplugs 9-3SS
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x 9-5 Shift Knobs Leather
1 x ATF Saab 3309 (Automatic 02->)
1 x 9-3 ng900 Hood Protection Strip
2 x Throttle Bend for T5 94-99
1 x 9-3 /NG900 Grille
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x T7 3.5 Bar Fuel Pressure Regulator
2 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x ARP Ring Gear Bolts F25/F35
4 x Shift Rod Bushings
2 x Transmission Nut F35 F25
1 x 9-5 Textile Mats 98-07
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Shifter Top Ghost Logo
1 x Slave Cyl
2 x Aluminum Flywheel For NG900/9-3
2 x Flywheel Twin Disk 7.25in B2xx
2 x Viggen Fog Air Intake
1 x Aero Clutch Kit 9-5
2 x Shifter Mount Kit 93ss
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Sport Transmission Mount 9-3/900 (Automatic)
3 x ShortShift Kit 93ss
2 x 9-5 Rear Brake rotor See Description
3 x 9-3/NG900 Shift Knobs Leather
2 x BSR Optiflow Intake 4cyl
2 x Rear Pedestal Spoiler 9-3 SS
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3 Rear Ashtray
1 x Steering Rod Bushings NG900/93
2 x BSR Optiflow Replacement Filter V6 2.8
1 x Rear spring perches Adjustable NG900/9-3
1 x BSR Optiflow Intake 4cyl w SAI
3 x Basic Subframe Brace
1 x 9-3 ng900 radio wires
1 x Downpipe 2.8T XWD (4wd)
1 x Griffin logo Shifter Top
4 x Genuine Saab 4cyl Oil Filters
1 x Rear Camber Shims Kit 6pcs
1 x Steering Coupler 9-3 99-02
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Con Rods V6 2.8L 155.8mm
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
3 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Machined Control Arm Kit
1 x 20th Viggen logo Shifter Top
1 x Downpipe 2.8T FWD (2wd)
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
3 x B207 Coolant Cap
2 x 9-3 / 900 Uprated Front ARB Bushings
3 x Adaptor Harness Handsfree 01-
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Midpipe 2.8T FWD (2wd)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Midpipe 2.8T XWD (4wd)
1 x Injectors 175hp Stg3 (Set4)
1 x BSR Optiflow Intake V6 2.8t
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x BSR 9-5 2010-2011 V6 300Hp
3 x Clear Little Fender Blinkers Factory Saab
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Mat Set Textile Jet Black 9-5 10-
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Crush Sleeve F35 F25
1 x BSR 9-5 3.0T V6 200Hp
2 x Front Camber Adjustment Bolts
1 x B207 Upper Radiator Coolant T
1 x 9-5 Wheel 10-Spoke 16in.
1 x Forge Bypass Valve Cobalt/HHR TC
3 x Brake Vac pump seals
3 x Crank Vent Kit #6 T7 4cyl
3 x Downpipe Hardware Kit
2 x Rear Engine Mount 4cyl
2 x Viggen Front Brake Disk Pair 308mm
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x 4 Cyl 2.0 Coolant Tank
2 x Hood Emblem 9-3 SS/sc 03- All
3 x Throttle Body T7
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Oil Cooler Adaptor B2X5
1 x T7 Injector Spacer Kit
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Mat Set Textile Parchment 9-5 10-
1 x Viggen Clutch Kit 99-02
2 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Oil Cap 9-3SS V6 "Ghost"
1 x 9-5 Open Air Prefilter
1 x Filter 9-5 Cabin Air
1 x Replacement Filter for Open air 9-3 T7
1 x V6 Tank Float - SparePart
1 x Open Air Intake 9000 93-98
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Fog light Replacement Panels 99-01
1 x Replacement Hardware Pack 6-Point
1 x Metal Steering Wheel Buttons
1 x Balance Shaft Tensioner Delete
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Fuel Line Clip
2 x Direct Ignition T5 RED
1 x Mass Airflow Meter T7
1 x BSR 9-5 260Hp 2006-
1 x Optical Cable Connector (Onstar Delete)
1 x Turbo Bypass Valve
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Remote Button NG900
1 x Fog light 9-3 Right 99-00
1 x Coolant Bypass Valve 9-5
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Cabin Vent Fan
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Fog light 9-3 left 99-00
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Exhaust manifold Stud Kit
1 x Turbo Conversion Pipe 900 9-3 T5
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
$41,356.92
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail