$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x c900 Performance Brake lines
3 x Clear Little Fender Blinkers Factory Saab
1 x PPC 3 Volvo Diagnostic System
1 x Saab black Keychain
1 x Viggen Titanium KeyChain
2 x SCNA Christmas Calendar
1 x Replacement V6 Coolant Cap
1 x Troll Head Plug
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Flex Pipe 900 94-98 9-3 99-02
1 x 9-3 /NG900 Grille
1 x Exhaust manifold Stud Kit
1 x Fog light 9-3 Right 99-00
1 x Fog light Replacement Panels
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Fog light 9-3 left 99-00
2 x Exhaust Clamp Kit
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Antenna Plug NG900/9-3 hatchback
1 x JE Piston Rings 90.0mm 235/205
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Replacement Hardware Pack 6-Point
1 x Replacement Filter for Open air 9-3 T7
1 x Adaptor Harness Handsfree 01-
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Balance Shaft Tensioner Delete
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Head Stud Kit all 4cyl
1 x Steering Rod Bushings NG900/93
1 x Rear Engine Mount 4cyl
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Machined Control Arm Kit
1 x Headbolts (New Style)
2 x Steering Coupler 9-3 99-02
1 x Flywheel Twin Disk 7.25in B2xx
1 x Crush Sleeve F35 F25
1 x Shifter Top Ghost Logo
2 x Quaife Differential 9-5 and Viggen (F35)
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x 4340 Connecting Rods B204 B235
1 x Remote Button NG900
1 x Direct Ignition T7 Black
1 x Transmission Nut F35 F25
1 x Throttle Bend for T5 94-99
1 x Rod Bearings only Pauter Rods
1 x 20th Viggen logo Shifter Top
1 x Rear Camber Shims Kit 6pcs
1 x Griffin logo Shifter Top
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Crank Vent Kit #6 T7 4cyl
1 x Replacement Flywheel Insert NG900/9-3
1 x ARP Ring Gear Bolts F25/F35
1 x Direct Ignition T5 RED
1 x Oil Filter Re-locator
1 x 9-3 ng900 radio wires
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x T7 Head Plug NGK
1 x Oil Cap 9-3SS V6 "Griffin"
1 x 9-5 Aero Sill Protection
1 x 9-5 Textile Mats 98-07
1 x Aero Clutch Kit 9-5
1 x Weld Bungs -Taper- Race Only
1 x AEM Wideband Gauge Kit
1 x Map/MAT sensor weld bung
2 x Fuel Pressure Regulator 4.0 bar
1 x Universal / Special Request
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Injectors Green Giant 42lb (set 4)
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Rivetnuts Pair (2pcs)
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Open Air Intake 9000 93-98
1 x Limit Strap Coilover Add On Kit
1 x Intake Flange B2x4 T5
1 x Ignition Coil 9-3SS 2.8t and 2.8T
$14,478.24
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail