$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x 20th Viggen logo Shifter Top
2 x 9-5 Blend Flap Limit Lever 99-04
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x 9-3 Rear Ashtray
2 x Griffin logo Shifter Top
2 x Basic Subframe Brace
1 x SCNA Christmas Calendar
1 x Machined Control Arm Kit
1 x Rear Camber Shims Kit 6pcs
1 x Saab black Keychain
2 x Rear spring perches Adjustable NG900/9-3
3 x Limit Strap Coilover Add On Kit
1 x Viggen Titanium KeyChain
2 x Steering Coupler 9-3 99-02
2 x Turbo Conversion Pipe 900 9-3 T5
1 x T7 Head Plug NGK
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Con Rods V6 2.8L 155.8mm
1 x Troll Head Plug
1 x B207 Coolant Cap
1 x Replacement V6 Coolant Cap
1 x Fuel Pressure Regulator 4.0 bar
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x PPC - Upgrade from stage 1 to stage 3
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
2 x Custom Brake Lines RR 300mm Kit
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x MTF0063 Manual Gear oil
1 x AEM Wideband Gauge Kit
1 x Throttle Bend for T5 94-99
2 x Head Bolt Washers
4 x Exhaust Clamp Kit
4 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x PPC 3 Volvo Diagnostic System
1 x Brembo Brake Kit 315mm 9-3 SS
4 x Viggen Fog Air Intake
1 x Adaptor Harness Handsfree 01-
2 x 9-3 99-02,03 CV Antenna Adaptor
1 x Injectors Green Giant 42lb (set 4)
1 x Oil Cap 9-3SS V6 "Ghost"
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Brembo Kit 315mm Hawk HPS Pads
2 x ARP Exhaust Manifold Stud kit Stainless
2 x Oil Cap GM "HHR"
3 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
5 x Cat back for Viggen 2.5in
3 x Exhaust manifold Stud Kit
2 x Short Shifter HHR Cobalt F35 F40
2 x Forge Bypass Valve Cobalt/HHR TC
1 x Turbo to Downpipe Flange B207
1 x Moog Ball Joint
1 x Downpipe Hardware Kit
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Rivetnuts Pair (2pcs)
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Storage Tray / Ashtray Kit 9-5 10-
2 x Oil Cooler Adaptor B2X5
1 x ARP Ring Gear Bolts F25/F35
1 x Steering Rod Bushings NG900/93
1 x 9000 Shifter Bushing Repair Kit
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x 9000 High Performance Brake Line Kit '95-'98
1 x Flywheel Twin Disk 7.25in B2xx
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Oil Filter Re-locator
1 x Open Air Intake 9000 93-98
1 x Sport Transmission Mount 9-3/900 (Automatic)
3 x Flex Pipe 900 94-98 9-3 99-02
1 x Injectors Siemens 60lb 630cc (set 4)
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Shifter Mount Kit Cobalt/ HHR
1 x BSR 9-5 2010-2011 V6 300Hp
$19,345.42
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail