$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x MTF0063 Manual Gear oil
1 x Limit Strap Coilover Add On Kit
2 x 9000 Shifter Bushing Repair Kit
1 x Con Rods V6 2.8L 155.8mm
1 x T7 Head Plug NGK
2 x Troll Head Plug
1 x Replacement V6 Coolant Cap
1 x B207 Coolant Cap
1 x Intake Flange B2x4 T5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Universal / Special Request
1 x AEM Wideband Gauge Kit
1 x Head Bolt Washers
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Brake Vac pump seals
2 x PPC - Upgrade from stage 1 to stage 3
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Transmission Nut F35 F25
1 x Replacement Flywheel Insert NG900/9-3
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Mass Airflow Meter T7
2 x Adaptor Harness Handsfree 01-
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Exhaust Clamp Kit
1 x Rear spring perches Adjustable NG900/9-3
3 x K&N Filter Service Kit
3 x Midpipe 2.0T 07-11 FWD (2wd)
2 x ATF Saab 3309 (Automatic 02->)
2 x Shifter Alignment Pins (Set 2)
1 x Bulb Switch Light
1 x Headlight Bulb H7 Longer Life
1 x Floormats BSR 9-5
1 x Genuine Saab 4cyl Oil Filters
1 x 9-5 Shift Knobs Leather
1 x Headbolts (New Style)
2 x Shift Rod Bushings
1 x BSR 9-5 3.0T V6 200Hp
1 x Direct Ignition T7 Black
1 x 9-5 Open Air Prefilter
1 x Crank Vent Kit #6 T7 4cyl
3 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Drop in Sport Filter 9-5
2 x Exhaust manifold Stud Kit
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
3 x T7 3.5 Bar Fuel Pressure Regulator
3 x T7 Injector Spacer Kit
2 x Shifter Mount Kit Cobalt/ HHR
1 x BBS Center Cap for 9-2x RK small caps
2 x Oil Cooler Adaptor B2X5
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x Turbo Conversion Pipe 900 9-3 T5
2 x Throttle Bend for T5 94-99
1 x Viggen Fog Air Intake
1 x Oil Cap 9-3SS V6 "Ghost"
1 x 9000 Intercooler ETS
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Coreganizer
1 x Oil Cap 9-3SS "Ghost"
1 x IAT Weld Bung T5/Bosch
1 x Shifter Top Ghost Logo
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Fog light Replacement Panels 99-01
2 x Oil Cap GM "HHR"
3 x Short Shifter HHR Cobalt F35 F40
2 x Forge Bypass Valve Cobalt/HHR TC
1 x 9-3 /NG900 Grille
1 x Injectors Green Giant 42lb (set 4)
1 x Cigarette Lighter
1 x Valve Cover Gasket Set 4cyl
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Midpipe 2.8T FWD (2wd)
1 x 9-5 Aero Sill Protection
1 x Fog light 9-3 Right 99-00
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
2 x 9-5 Wheel 5-Spoke Twin 17in
1 x Oil Filter Re-locator
1 x Open Air Intake 9000 93-98
1 x Crush Sleeve F35 F25
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Moog Ball Joint
$13,638.87
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail