$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x JE Piston Ring (1cyl) 90.5mm 235/205/204
7 x Headbolts (New Style)
5 x Head Stud Kit all 4cyl
4 x Oil Filter Re-locator
2 x Forge Bypass Valve Cobalt/HHR TC
2 x Short Shifter HHR Cobalt F35 F40
1 x Oil Cap GM "HHR"
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
3 x Mass Airflow Meter T7
3 x Flex Pipe 900 94-98 9-3 99-02
3 x Replacement Filter for Open air 9-3 T7
2 x Cat back for Viggen 2.5in
1 x PPC - Upgrade from stage 1 to stage 3
1 x Saab black Keychain
1 x Basic Subframe Brace
2 x Oil Cooler Adaptor B2X5
1 x Steering Rod Bushings NG900/93
2 x T7 Injector Spacer Kit
2 x Turbo Conversion Pipe 900 9-3 T5
2 x Rear spring perches Adjustable NG900/9-3
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
3 x 9-3 / 900 Uprated Front ARB Bushings
1 x Throttle Bend for T5 94-99
1 x Viggen Fog Air Intake
3 x Steering Coupler 9-3 99-02
1 x Rear Camber Shims Kit 6pcs
2 x Limit Strap Coilover Add On Kit
1 x Machined Control Arm Kit
2 x 9-3 / 900 Uprated Suspension Bushings Inner
3 x Balance Shaft Tensioner Delete
1 x Adaptor Harness Handsfree 01-
1 x Head Bolt Washers
1 x Fog light 9-3 left 99-00
3 x 9-5 Aero Sill Protection
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x 9-5 Blend Flap Limit Lever 99-04
2 x MTF0063 Manual Gear oil
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x 20th Viggen logo Shifter Top
3 x Aluminum Flywheel For NG900/9-3
3 x Turbo Bypass Valve
3 x Viggen Clutch Kit 99-02
1 x Crank Vent Kit #6 T7 4cyl
1 x Direct Ignition T7 Black
2 x Shift Rod Bushings
2 x Flywheel Twin Disk 7.25in B2xx
1 x Rear Engine Mount 4cyl
2 x Genuine Saab 4cyl Oil Filters
2 x ARP Ring Gear Bolts F25/F35
1 x Quaife Differential 9-5 and Viggen (F35)
2 x Replacement Hardware Pack 6-Point
2 x 9-5 Intercooler ETS
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x 9000 Intercooler ETS
5 x ARP Exhaust Manifold Stud kit Stainless
2 x 9000 Shifter Bushing Repair Kit
1 x Con Rods V6 2.8L 155.8mm
1 x V6 Tank Float - SparePart
2 x 9-5 Exhaust Flex Pipe Stainless
1 x 9-5 Rear Brake rotor See Description
1 x ATF Saab 3309 (Automatic 02->)
2 x IAT Weld Bung T5/Bosch
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x 9-5 Shift Knobs Leather
1 x Injectors Green Giant 42lb (set 4)
2 x Open Air Intake 9000 93-98
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Clear Little Fender Blinkers Factory Saab
1 x Crush Sleeve F35 F25
1 x 9000 High Performance Brake Line Kit '95-'98
2 x JE Piston Rings 90.0mm 235/205
3 x 4340 Connecting Rods B204 B235
2 x Rod Bearings only Pauter Rods
1 x Upgrade Valve Springs T5 Cars
1 x T7 Head Plug NGK
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Griffin logo Shifter Top
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Oil Cap 9-3SS V6 "Ghost"
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x BSR Optiflow Intake 4cyl
1 x Turbo to Downpipe Flange B207
1 x Shifter Mount Kit 93ss
1 x B207 Upper Radiator Coolant T
1 x Direct Ignition T5 RED
1 x Remote Button NG900
1 x Exhaust manifold Stud Kit
1 x Troll Head Plug
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Drop in Sport Filter 9-5
$28,352.10
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail