$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x 3 Point Hardware
2 x Replacement V6 Coolant Cap
1 x c900 Performance Brake lines
3 x Oil Cap GM "HHR"
1 x Short Shifter HHR Cobalt F35 F40
1 x Forge Bypass Valve Cobalt/HHR TC
2 x Shifter Mount Kit Cobalt/ HHR
1 x Rear Camber Shims Kit 6pcs
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x T5 3.0 Bar Map Sensor Adaptor
3 x Injectors Green Giant 42lb (set 4)
1 x BSR Optiflow Intake 4cyl
1 x Fuel Pressure Regulator 4.0 bar
1 x Map/MAT sensor weld bung
3 x Moog Ball Joint
1 x Universal / Special Request
2 x PPC - Upgrade from stage 1 to stage 3
1 x Rivetnuts Pair (2pcs)
2 x Intake Flange B2x4 T5
3 x Head Bolt Washers
2 x Injectors Siemens 60lb 630cc (set 4)
3 x IAT Weld Bung T5/Bosch
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Saab black Keychain
3 x 20th Viggen logo Shifter Top
2 x Floormats BSR 9-3 99-02 900 94-98
2 x 9-5 Exhaust Flex Pipe Stainless
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
4 x Shift Rod Bushings
2 x ARP Exhaust Manifold Stud kit Stainless
1 x 9000 High Performance Brake Line Kit '95-'98
1 x Cat Back Exh for 9000 CS, CSE AERO
2 x Open Air Intake 9000 93-98
1 x 9000 Intercooler ETS
4 x Crush Sleeve F35 F25
2 x Exhaust manifold Stud Kit
1 x Fog light 9-3 Right 99-00
1 x Shifter Top Ghost Logo
1 x 9-3/NG900 Shift Knobs Leather
1 x 9-3 Rear Ashtray
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Fog light Replacement Panels
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Adaptor Harness Handsfree 01-
1 x ARP Ring Gear Bolts F25/F35
1 x Replacement Flywheel Insert NG900/9-3
1 x 9-3 ng900 Hood Protection Strip
1 x 9-5 Blend Flap Limit Lever 99-04
2 x 9-3 /NG900 Grille
2 x Alu Hybrid Flywheel For NG900/9-3
3 x Flywheel Twin Disk 7.25in B2xx
3 x MTF0063 Manual Gear oil
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Fog light 9-3 left 99-00
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Coreganizer
1 x Slave Cyl
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Antenna Plug NG900/9-3 hatchback
2 x Rear Engine Mount 4cyl
1 x Aluminum Flywheel For NG900/9-3
2 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Griffin logo Shifter Top
2 x 9-3 ng900 radio wires
3 x Transmission Nut F35 F25
3 x Machined Control Arm Kit
1 x Rear spring perches Adjustable NG900/9-3
1 x Steering Rod Bushings NG900/93
1 x Throttle Bend for T5 94-99
2 x Oil Filter Re-locator
1 x Rod Bearings only Pauter Rods
1 x Mass Airflow Meter T7
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Direct Ignition T5 RED
1 x Cat back for Viggen 2.5in
1 x Fuel Line Clip
1 x Headbolts (New Style)
1 x Viggen Fog Air Intake
1 x Flex Pipe 900 94-98 9-3 99-02
1 x JE Piston Rings 90.0mm 235/205
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x ATF Saab 3309 (Automatic 02->)
1 x Air Filter 06 version (All 9-5)
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x 4340 Connecting Rods B204 B235
2 x Clear Little Fender Blinkers Factory Saab
1 x Oil Cap 9-3SS V6 "Griffin"
1 x 9-5 Aero Sill Protection
1 x Oil Cap 9-3SS V6 "Ghost"
1 x B207 Upper Radiator Coolant T
1 x Optical Cable Connector (Onstar Delete)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Oil Cooler Adaptor B2X5
2 x Steering Coupler 9-3 99-02
1 x Oil Cap 9-3SS "Ghost"
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Brake Vac pump seals
1 x Front Camber Adjustment Bolts
1 x v6oilcoolplate
1 x v6 header flange
1 x V6 Tank Float - SparePart
1 x Aero Clutch Kit 9-5
1 x 9-5 Shift Knobs Leather
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9000 Shifter Bushing Repair Kit
1 x SCNA Christmas Calendar
1 x Downpipe 2.8T FWD (2wd)
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
$23,681.21
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail