$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Replacement Hardware Pack 6-Point
4 x Mass Airflow Meter T7
6 x Rear Engine Mount 4cyl
5 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Direct Ignition T5 RED
1 x Fog light 9-3 left 99-00
2 x Antenna Plug NG900/9-3 hatchback
2 x 9-3 / 900 Uprated Suspension Bushings Inner
3 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
4 x Flywheel Twin Disk 7.25in B2xx
1 x 9-3 / 900 Uprated Front ARB Bushings
5 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x 20th Viggen logo Shifter Top
2 x ARP Ring Gear Bolts F25/F35
5 x Shifter Top Ghost Logo
4 x Sport Transmission Mount 9-3/900 (Automatic)
3 x Replacement Flywheel Insert NG900/9-3
2 x Aluminum Flywheel For NG900/9-3
1 x 9-5 Blend Flap Limit Lever 99-04
3 x Shift Rod Bushings
4 x SCNA Christmas Calendar
2 x Replacement V6 Coolant Cap
2 x Con Rods V6 2.8L 155.8mm
1 x Viggen Titanium KeyChain
3 x Machined Control Arm Kit
2 x AEM Wideband Gauge Kit
2 x Throttle Bend for T5 94-99
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Viggen Fog Air Intake
2 x Throttle Body T7
2 x 9-5 Aero Sill Protection
2 x Turbo Bypass Valve
2 x Remote Button NG900
4 x Crush Sleeve F35 F25
1 x Exhaust Clamp Kit
1 x Genuine Saab 4cyl Oil Filters
2 x Downpipe Hardware Kit
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
3 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x PPC - Upgrade from stage 1 to stage 3
1 x 9-3 ng900 Hood Protection Strip
2 x Fog light Replacement Panels
2 x Shifter Mount Kit 93ss
2 x Clear Little Fender Blinkers Factory Saab
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
2 x Fog light 9-3 Right 99-00
2 x ShortShift Kit 93ss
3 x Front Camber Adjustment Bolts
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x B207 Upper Radiator Coolant T
2 x Adaptor Harness Handsfree 01-
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Metal Steering Wheel Buttons
1 x 3 Point Hardware
2 x V6 Tank Float - SparePart
1 x Floormats BSR 9-3SS/SC
1 x Rear spring perches Adjustable NG900/9-3
1 x Downpipe 2.8T FWD (2wd)
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Downpipe 2.8T XWD (4wd)
4 x Brake Vac pump seals
2 x Shifter Alignment Pins (Set 2)
2 x Rear Camber Shims Kit 6pcs
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Map/MAT sensor weld bung
3 x Head Bolt Washers
1 x Steering Coupler 9-3 99-02
2 x Header Flange Stainless Blended Transition B2x4,B2x5
3 x Oil Cap 9-3SS "Ghost"
2 x Oil Cap 9-3SS V6 "Ghost"
4 x Exhaust manifold Stud Kit
1 x Midpipe 2.8T XWD (4wd)
2 x Upgrade Valve Springs T5 Cars
3 x T7 Head Plug NGK
3 x Balance Shaft Tensioner Delete
2 x ARP Exhaust Manifold Stud kit Stainless
3 x Flex Pipe 900 94-98 9-3 99-02
1 x Cat back for Viggen 2.5in
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Headlight Bulb H7 Longer Life
2 x 9-5 Exhaust Flex Pipe Stainless
2 x Oil Cap 9-3SS V6 "Griffin"
1 x Cigarette Lighter
2 x 9-5 Shift Knobs Leather
1 x 9-5 Textile Mats 98-07
1 x Oil Cooler Adaptor B2X5
4 x Rod Bearings only Pauter Rods
3 x Oil Filter Re-locator
3 x JE Piston Rings 90.0mm 235/205
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x Headbolts (New Style)
1 x IAT Weld Bung T5/Bosch
1 x v6oilcoolplate
1 x v6 header flange
1 x 9-3 ng900 radio wires
1 x Intake Flange B2x4 T5
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Transmission Nut F35 F25
1 x Moog Ball Joint
1 x Griffin logo Shifter Top
1 x Saab black Keychain
3 x Crank Vent Kit #6 T7 4cyl
1 x Fuel Line Clip
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Sparkplugs 9-3SS
2 x BSR Optiflow Intake 4cyl
1 x Head Stud Kit all 4cyl
1 x PPC 3 Volvo Diagnostic System
1 x Floormats BSR 9-5
1 x 4340 Connecting Rods B204 B235
1 x B207 Coolant Cap
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Troll Head Plug
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Slave Cyl
1 x Viggen Clutch Kit 99-02
1 x 9000 Shifter Bushing Repair Kit
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Viggen Front Brake Disk Pair 308mm
1 x 9-3/NG900 Shift Knobs Leather
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Valve Cover Gasket Set 4cyl
$34,080.72
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail