$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x 4340 Connecting Rods B204 B235
5 x Oil Filter Re-locator
3 x JE Piston Rings 90.0mm 235/205
4 x Clear Little Fender Blinkers Factory Saab
3 x Fog light 9-3 Right 99-00
1 x 9-3 /NG900 Grille
1 x Fog light Replacement Panels
7 x Rear Camber Shims Kit 6pcs
1 x 20th Viggen logo Shifter Top
3 x Steering Rod Bushings NG900/93
6 x Basic Subframe Brace
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
3 x Throttle Bend for T5 94-99
3 x Sport Transmission Mount 9-3/900 (Automatic)
5 x Shift Rod Bushings
2 x ARP Ring Gear Bolts F25/F35
1 x Aluminum Flywheel For NG900/9-3
4 x Turbo Conversion Pipe 900 9-3 T5
3 x Shifter Top Ghost Logo
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
3 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Quaife Differential 9-5 and Viggen (F35)
2 x Replacement Flywheel Insert NG900/9-3
4 x Oil Cooler Adaptor B2X5
2 x Viggen Fog Air Intake
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Slave Cyl
2 x Transmission Nut F35 F25
2 x c900 Performance Brake lines
1 x Viggen Titanium KeyChain
2 x SCNA Christmas Calendar
3 x PPC - Upgrade from stage 1 to stage 3
1 x Rivetnuts Pair (2pcs)
1 x AEM Wideband Gauge Kit
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x K&N Filter Service Kit
2 x Shifter Alignment Pins (Set 2)
1 x ATF Saab 3309 (Automatic 02->)
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Injectors Green Giant 42lb (set 4)
1 x MTF0063 Manual Gear oil
2 x T5 3.0 Bar Map Sensor Adaptor
3 x Map/MAT sensor weld bung
1 x Universal / Special Request
3 x Head Bolt Washers
1 x Moog Ball Joint
1 x Fuel Pressure Regulator 4.0 bar
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Intake Flange B2x4 T5
1 x Crank Vent Kit #6 T7 4cyl
2 x Short Shifter HHR Cobalt F35 F40
1 x T7 Head Plug NGK
1 x Custom Brake Lines RR 300mm Kit
2 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
2 x BBS Center Cap for 9-2x RK small caps
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x 9-5 Wheel 5-Spoke Twin 17in
2 x Balance Shaft Tensioner Delete
3 x Troll Head Plug
1 x 9-3 ng900 Hood Protection Strip
1 x Front Camber Adjustment Bolts
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Spec Light Flywheel For 9-5 4cyl 99-09
2 x Air Filter 06 version (All 9-5)
2 x Downpipe Hardware Kit
1 x Oil Pressure Switch
1 x Filter 9-5 Cabin Air
3 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Aero Clutch Kit 9-5
1 x Genuine Saab 4cyl Oil Filters
1 x Mass Airflow Meter T7
3 x 9-5 Exhaust Flex Pipe Stainless
1 x Headbolts (New Style)
1 x Direct Ignition T7 Black
1 x Injectors Siemens 80lb 875cc (set 4)
1 x V6 Tank Float - SparePart
1 x 9-3 ng900 radio wires
1 x Front Camber Adjustment Bolts
3 x Exhaust manifold Stud Kit
3 x IAT Weld Bung T5/Bosch
1 x Hood Emblem 9-5 All
1 x Exhaust Clamp Kit
1 x Oil Cap GM "HHR"
2 x Shifter Mount Kit Cobalt/ HHR
1 x Forge Bypass Valve Cobalt/HHR TC
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Fuel Line Clip
1 x Brake Vac pump seals
1 x B207 Coolant Cap
1 x Oil Cap 9-3SS "Ghost"
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Turbo to Downpipe Flange B207
1 x Oil Cap 9-3SS V6 "Griffin"
3 x Rear spring perches Adjustable NG900/9-3
3 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Downpipe 2.8T FWD (2wd)
2 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x v6 2.8t SAI Delete Kit
1 x Weld Bungs -Taper- Race Only
1 x ShortShift Kit 93ss
1 x Downpipe 2.8T XWD (4wd)
1 x Open Air Intake 9000 93-98
2 x Midpipe 2.8T XWD (4wd)
3 x Limit Strap Coilover Add On Kit
1 x B207 Upper Radiator Coolant T
1 x v6oilcoolplate
2 x Steering Coupler 9-3 99-02
1 x Brembo Brake Kit 315mm 9-3 SS
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x v6 header flange
1 x Shifter Mount Kit 93ss
1 x 9000 Shifter Bushing Repair Kit
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Midpipe 2.8T FWD (2wd)
4 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x Griffin logo Shifter Top
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Viggen Front Brake Disk Pair 308mm
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x BSR Optiflow Intake 4cyl
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x BSR Optiflow Intake V6 2.8t
1 x BSR Optiflow Intake 4cyl w SAI
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x ARP Exhaust Manifold Stud kit Stainless
1 x 9000 Intercooler ETS
2 x Throttle Body T7
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x 9-5 Open Air Prefilter
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Machined Control Arm Kit
1 x Head Stud Kit all 4cyl
$36,564.74
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail