$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
5 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x ARP Exhaust Manifold Stud kit Stainless
3 x Cat back for Viggen 2.5in
5 x PPC - Upgrade from stage 1 to stage 3
3 x 9-3 /NG900 Grille
1 x 9-3 ng900 Hood Protection Strip
2 x Fog light Replacement Panels
3 x Clear Little Fender Blinkers Factory Saab
1 x Fog light 9-3 left 99-00
2 x c900 Performance Brake lines
2 x Fog light 9-3 Right 99-00
3 x Antenna Plug NG900/9-3 hatchback
3 x ATF Saab 3309 (Automatic 02->)
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
3 x Injectors Green Giant 42lb (set 4)
3 x Forge Bypass Valve Cobalt/HHR TC
5 x MTF0063 Manual Gear oil
1 x Downpipe Hardware Kit
1 x Oil Cap GM "HHR"
3 x Rivetnuts Pair (2pcs)
1 x 20th Viggen logo Shifter Top
2 x 9-5 Blend Flap Limit Lever 99-04
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Troll Head Plug
2 x Replacement V6 Coolant Cap
3 x T7 3.5 Bar Fuel Pressure Regulator
2 x 9-3 Rear Ashtray
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Throttle Bend for T5 94-99
2 x Turbo Conversion Pipe 900 9-3 T5
1 x 9-3 ng900 radio wires
2 x Griffin logo Shifter Top
1 x 9-3 99-02,03 CV Antenna Adaptor
2 x Front Brake Pads 9-5 9-3 900 LOW DUST
2 x 9-5 Aero Sill Protection
1 x Basic Subframe Brace
3 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Slave Cyl
1 x Floormats BSR 9-5
1 x 9-5 Intercooler ETS
1 x Drop in Sport Filter 9-5
2 x Spec Light Flywheel For 9-5 4cyl 99-09
2 x Bulb Switch Light
1 x Adaptor Harness Handsfree 01-
2 x Aero Clutch Kit 9-5
1 x Cigarette Lighter
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
2 x BSR 9-5 260Hp 2006-
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Coolant Bypass Valve 9-5
3 x BSR 9-5 3.0T V6 200Hp
2 x Head Bolt Washers
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Machined Control Arm Kit
1 x Downpipe 2.8T XWD (4wd)
1 x Universal / Special Request
1 x Downpipe 2.8T FWD (2wd)
3 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x K&N Filter Service Kit
1 x BSR Optiflow Intake V6 2.8t
2 x BSR Optiflow Intake 4cyl
1 x Midpipe 2.8T FWD (2wd)
2 x Brake Vac pump seals
2 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x V6 Tank Float - SparePart
2 x Sparkplugs 9-3SS
2 x Ignition Coil 9-3SS 2.8t and 2.8T
2 x Hood Emblem 9-3 SS/sc 03- All
1 x IAT Weld Bung T5/Bosch
2 x v6 2.8t SAI Delete Kit
1 x Weld Bungs -Taper- Race Only
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x 9-5 AERO 308mm Front Brake Rotor / Disk
3 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
3 x Viggen Front Brake Disk Pair 308mm
1 x Custom Brake Lines RR 300mm Kit
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x BSR 9-5 2010-2011 V6 300Hp
1 x BSR Optiflow Intake 4cyl w SAI
2 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9000 Shifter Bushing Repair Kit
2 x Genuine Saab 4cyl Oil Filters
1 x Brembo Kit 315mm Hawk HPS Pads
1 x 9-5 High Performance Brake Line Kit
1 x Fuel Line Clip
1 x AEM Wideband Gauge Kit
1 x 4 Cyl 2.0 Coolant Tank
1 x B207 Upper Radiator Coolant T
1 x Turbo to Downpipe Flange B207
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Viggen Clutch Kit 99-02
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Valve Cover Gasket Set 4cyl
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x 9-5 Open Air Prefilter
1 x Oil Pressure Switch
1 x Crush Sleeve F35 F25
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Mat Set Textile Shark Grey 9-5 10-
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Injectors 175hp Stg3 (Set4)
1 x v6 header flange
1 x v6oilcoolplate
1 x Crank Vent Kit #6 T7 4cyl
1 x BBS Center Cap for 9-2x RK small caps
1 x PPC 3 Volvo Diagnostic System
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Open Air Intake 9000 93-98
1 x Headlight Bulb H7 Longer Life
2 x Throttle Body T7
2 x Saab black Keychain
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Rear Brake Pads 9-5 Later Style
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Cat Back Exh for 9000 CS, CSE AERO
$35,618.35
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail