$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x SCNA Christmas Calendar
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Universal / Special Request
1 x Moog Ball Joint
1 x IAT Weld Bung T5/Bosch
1 x Intake Flange B2x4 T5
1 x Injectors Siemens 80lb 875cc (set 4)
2 x PPC - Upgrade from stage 1 to stage 3
1 x AEM Wideband Gauge Kit
1 x Map/MAT sensor weld bung
1 x Header Flange Stainless Blended Transition B2x4,B2x5
3 x Rivetnuts Pair (2pcs)
3 x Clear Little Fender Blinkers Factory Saab
1 x c900 Performance Brake lines
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Forge Bypass Valve Cobalt/HHR TC
1 x K&N Filter Service Kit
2 x Filter 9-5 Cabin Air
1 x Oil Pressure Switch
1 x Genuine Saab 4cyl Oil Filters
1 x BSR 9-5 260Hp 2006-
1 x Headbolts (New Style)
1 x Drop in Sport Filter 9-5
2 x T7 Injector Spacer Kit
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
3 x ARP Exhaust Manifold Stud kit Stainless
1 x 9-5 Aero Sill Protection
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x 9-5 Intercooler ETS
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Aero Clutch Kit 9-5
1 x Shift Rod Bushings
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Slave Cyl
1 x Spec Light Flywheel For 9-5 4cyl 99-09
2 x Head Stud Kit all 4cyl
1 x Floormats BSR 9-3SS/SC
2 x Midpipe 2.8T FWD (2wd)
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Rear Pedestal Spoiler 9-3 SS
2 x V6 Tank Float - SparePart
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x B207 Upper Radiator Coolant T
1 x MTF0063 Manual Gear oil
1 x Optical Cable Connector (Onstar Delete)
1 x Hood Emblem 9-3 SS/sc 03- All
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Metal Steering Wheel Buttons
2 x Midpipe 2.8T XWD (4wd)
1 x Brake Vac pump seals
1 x Coreganizer
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Front Camber Adjustment Bolts
1 x BSR Optiflow Intake V6 2.8t
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x 3 Point Hardware
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Shifter Mount Kit 93ss
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Adaptor Harness Handsfree 01-
2 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x BSR Optiflow Intake 4cyl
1 x ShortShift Kit 93ss
1 x Downpipe 2.8T XWD (4wd)
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Midpipe 2.0T 07-11 FWD (2wd)
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x 20th Viggen logo Shifter Top
1 x Air Filter 06 version (All 9-5)
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Basic Subframe Brace
2 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-3 /NG900 Grille
1 x ATF Saab 3309 (Automatic 02->)
1 x Rear Engine Mount 4cyl
1 x Exhaust Clamp Kit
1 x Exhaust manifold Stud Kit
2 x Flex Pipe 900 94-98 9-3 99-02
3 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Oil Cooler Adaptor B2X5
1 x Remote Button NG900
1 x Direct Ignition T5 RED
2 x Viggen Fog Air Intake
2 x 9-5 High Performance Brake Line Kit
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Fog light Replacement Panels
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Oil Cap 9-3SS V6 "Ghost"
2 x Head Bolt Washers
1 x Griffin logo Shifter Top
1 x Weld Bungs -Taper- Race Only
1 x BSR 9-5 2010-2011 V6 300Hp
2 x v6 header flange
1 x Fuel Pressure Regulator 4.0 bar
1 x Turbo to Downpipe Flange B207
1 x Oil Cap 9-3SS "Ghost"
1 x 9-5 Open Air Prefilter
1 x Upgrade Valve Springs T5 Cars
1 x 9-3 SS Akebono Rear Pads
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x v6oilcoolplate
1 x Replacement V6 Coolant Cap
1 x Cat back for Viggen 2.5in
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Custom Brake Lines RR 300mm Kit
$25,775.48
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail