$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
3 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Oil Cooler Adaptor B2X5
3 x Turbo Conversion Pipe 900 9-3 T5
1 x SCNA Christmas Calendar
1 x Viggen Titanium KeyChain
3 x Clear Little Fender Blinkers Factory Saab
1 x c900 Performance Brake lines
2 x 20th Viggen logo Shifter Top
2 x 9-3/NG900 Shift Knobs Leather
1 x Adaptor Harness Handsfree 01-
2 x Griffin logo Shifter Top
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-3 Rear Ashtray
2 x Replacement Filter for Open air 9-3 T7
2 x Downpipe Hardware Kit
1 x Fuel Line Clip
2 x Direct Ignition T7 Black
1 x Crush Sleeve F35 F25
1 x Genuine Saab 4cyl Oil Filters
3 x Crank Vent Kit #6 T7 4cyl
1 x Mass Airflow Meter T7
1 x Direct Ignition T5 RED
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Troll Head Plug
1 x B207 Coolant Cap
1 x Limit Strap Coilover Add On Kit
2 x Replacement V6 Coolant Cap
1 x T7 Head Plug NGK
1 x Con Rods V6 2.8L 155.8mm
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Basic Subframe Brace
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x T7 Injector Spacer Kit
1 x Rear Camber Shims Kit 6pcs
1 x Viggen Fog Air Intake
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
2 x 9-5 Aero Sill Protection
1 x Fog light Replacement Panels 99-01
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Hood Emblem 9-5 All
1 x Drop in Sport Filter 9-5
2 x PPC - Upgrade from stage 1 to stage 3
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x BSR 9-5 3.0T V6 200Hp
1 x Bulb Switch Light
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Headlight Bulb H7 Longer Life
2 x Saab black Keychain
1 x BSR 9-5 260Hp 2006-
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Cigarette Lighter
2 x 9-5 Open Air Prefilter
1 x Oil Pressure Switch
1 x Head Stud Kit all 4cyl
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Shift Rod Bushings
1 x Exhaust manifold Stud Kit
1 x 9-3 / 900 Uprated Front ARB Bushings
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9-3 ng900 radio wires
1 x Turbo Bypass Valve
1 x 9-5 Blend Flap Limit Lever 99-04
1 x V6 Tank Float - SparePart
1 x 9-3 SS Akebono Rear Pads
1 x Rivetnuts Pair (2pcs)
1 x Filter 9-5 Cabin Air
1 x Fuel Pressure Regulator 4.0 bar
1 x MTF0063 Manual Gear oil
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x 9000 Shifter Bushing Repair Kit
1 x Balance Shaft Tensioner Delete
1 x Oil Cap 9-3SS "Ghost"
1 x Turbo to Downpipe Flange B207
1 x Shifter Top Ghost Logo
$14,281.63
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail