$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x B207 Coolant Cap
3 x Limit Strap Coilover Add On Kit
1 x Oil Cap GM "HHR"
1 x Short Shifter HHR Cobalt F35 F40
5 x Forge Bypass Valve Cobalt/HHR TC
1 x K&N Filter Service Kit
2 x MTF0063 Manual Gear oil
2 x ATF Saab 3309 (Automatic 02->)
2 x AEM Wideband Gauge Kit
3 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Viggen Titanium KeyChain
3 x Saab black Keychain
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x PPC 3 Volvo Diagnostic System
1 x Fog light Replacement Panels
3 x 9-5 Aero Sill Protection
1 x Machined Control Arm Kit
2 x 9-5 Exhaust Flex Pipe Stainless
3 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Oil Cooler Adaptor B2X5
1 x B207 Upper Radiator Coolant T
1 x v6oilcoolplate
1 x Brake Vac pump seals
2 x Steering Coupler 9-3 99-02
1 x Oil Cap 9-3SS V6 "Griffin"
1 x 20th Viggen logo Shifter Top
3 x v6 header flange
2 x Oil Cap 9-3SS "Ghost"
1 x T7 Head Plug NGK
1 x Troll Head Plug
2 x Fuel Line Clip
1 x Fog light Replacement Panels 99-01
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Hood Emblem 9-5 All
1 x Cigarette Lighter
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x T7 Injector Spacer Kit
1 x Mass Airflow Meter T7
1 x 9-5 Open Air Prefilter
1 x Coolant Bypass Valve 9-5
1 x Drop in Sport Filter 9-5
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Bulb Switch Light
2 x Downpipe Hardware Kit
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
2 x Clear Little Fender Blinkers Factory Saab
2 x Oil Pressure Switch
1 x Headbolts (New Style)
1 x Headlight Bulb H7 Longer Life
1 x Direct Ignition T7 Black
1 x Cabin Vent Fan
1 x Floormats BSR 9-5
1 x Genuine Saab 4cyl Oil Filters
1 x BSR 9-5 260Hp 2006-
1 x BSR 9-5 3.0T V6 200Hp
1 x Crank Vent Kit #6 T7 4cyl
2 x Crush Sleeve F35 F25
1 x Air Filter 06 version (All 9-5)
1 x Spec Light Flywheel For 9-5 4cyl 99-09
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Head Stud Kit all 4cyl
1 x SCNA Christmas Calendar
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Shifter Top Ghost Logo
1 x Quaife Differential 9-5 and Viggen (F35)
2 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Aluminum Flywheel For NG900/9-3
2 x BSR 9-5 2010-2011 V6 300Hp
1 x c900 Performance Brake lines
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x Shifter Alignment Pins (Set 2)
1 x Torque Mount Insert V6 Manual (XWD and FWD)
4 x Weld Bungs -Taper- Race Only
3 x Moog Ball Joint
3 x IAT Weld Bung T5/Bosch
3 x Intake Flange B2x4 T5
2 x PPC - Upgrade from stage 1 to stage 3
4 x T5 3.0 Bar Map Sensor Adaptor
1 x Head Bolt Washers
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Valve Cover Gasket Set 4cyl
1 x Shifter Mount Kit Cobalt/ HHR
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Cat back for Viggen 2.5in
1 x Exhaust manifold Stud Kit
1 x Transmission Nut F35 F25
2 x Turbo to Downpipe Flange B207
1 x Map/MAT sensor weld bung
1 x Midpipe 2.8T FWD (2wd)
1 x Front Camber Adjustment Bolts
1 x Rear spring perches Adjustable NG900/9-3
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Injectors Green Giant 42lb (set 4)
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x 9-5 High Performance Brake Line Kit
1 x Viggen Front Brake Disk Pair 308mm
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Rear Brake rotor See Description
1 x Brembo Kit 315mm Hawk HPS Pads
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Replacement Filter for Open air 9-3 T7
1 x Viggen Clutch Kit 99-02
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Rear Camber Shims Kit 6pcs
1 x Mat Set Black Rubber 9-5 10-
1 x Mat Set Textile Shark Grey 9-5 10-
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x 9-3 SS Akebono Rear Pads
1 x 9-3 /NG900 Grille
$22,195.72
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail