$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x ARP Ring Gear Bolts F25/F35
3 x Quaife Differential 9-5 and Viggen (F35)
4 x PPC 3 Volvo Diagnostic System
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x Aluminum Flywheel For NG900/9-3
3 x Balance Shaft Tensioner Delete
1 x 9-3 Rear Ashtray
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 9-3/NG900 Shift Knobs Leather
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Adaptor Harness Handsfree 01-
2 x 20th Viggen logo Shifter Top
1 x 9-5 Blend Flap Limit Lever 99-04
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 9-3 ng900 radio wires
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Griffin logo Shifter Top
1 x Exhaust manifold Stud Kit
1 x Flex Pipe 900 94-98 9-3 99-02
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Shifter Mount Kit Cobalt/ HHR
1 x Limit Strap Coilover Add On Kit
1 x 9000 Shifter Bushing Repair Kit
3 x Clear Little Fender Blinkers Factory Saab
1 x Short Shifter HHR Cobalt F35 F40
1 x Rivetnuts Pair (2pcs)
1 x AEM Wideband Gauge Kit
2 x Viggen Clutch Kit 99-02
5 x Shift Rod Bushings
2 x 9-3 /NG900 Grille
2 x Fog light 9-3 Right 99-00
1 x Transmission Nut F35 F25
2 x 9-3 ng900 Hood Protection Strip
2 x Fog light 9-3 left 99-00
2 x Rear Engine Mount 4cyl
1 x Shifter Top Ghost Logo
2 x Fog light Replacement Panels
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Antenna Plug NG900/9-3 hatchback
1 x Crush Sleeve F35 F25
1 x Cigarette Lighter
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x 9-5 Open Air Prefilter
1 x Headlight Bulb H7 Longer Life
1 x Saab black Keychain
2 x Troll Head Plug
3 x Upgrade Valve Springs T5 Cars
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Brake Vac pump seals
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Map/MAT sensor weld bung
1 x Steering Rod Bushings NG900/93
1 x Shifter Mount Kit 93ss
1 x Rear Camber Shims Kit 6pcs
1 x v6oilcoolplate
1 x Replacement Hardware Pack 6-Point
1 x Custom Brake Lines RR 300mm Kit
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Weld Bungs -Taper- Race Only
1 x IAT Weld Bung T5/Bosch
3 x JE Piston Rings 90.0mm 235/205
2 x Head Stud Kit all 4cyl
1 x Headbolts (New Style)
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x MTF0063 Manual Gear oil
1 x Downpipe Hardware Kit
1 x 9-5 Exhaust Flex Pipe Stainless
1 x PPC - Upgrade from stage 1 to stage 3
2 x Bulb Switch Light
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Shift Knobs Leather
1 x Fog light Replacement Panels 99-01
2 x 9-5 Wheel 5-Spoke Twin 17in
1 x Air Filter 06 version (All 9-5)
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Front Camber Adjustment Bolts
1 x Replacement Filter for Open air 9-3 T7
1 x Rear spring perches Adjustable NG900/9-3
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x 4340 Connecting Rods B204 B235
1 x Rod Bearings only Pauter Rods
1 x BSR 9-5 260Hp 2006-
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
$21,119.46
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail