$20.00

Steering Rod Bushings NG900/93
[4242669U]

Steering Rod Bushings NG900/93

Add to Cart

Date Added: Monday 11 April, 2011

by Seth Johnson

Great part for worn out replacement or to use in conjunction with the steering rack brace. When used with the steering brace, cowl shake is severely reduced and the steering is much more responsive. For $20 why wouldn't you install these?

Installation tips:
at 150,000 miles don't think the original bushing are just going to "fall out". I wasn't about to try and remove the entire arm assembly and put it on a bench so I used some "help". That help came in the form of a propane torch being careful not to turn the old rubber (or fire wall) into a molten fiery mess. Once the rubber was crispy the metal insert fell out with ease and the rubber as well (this was done after the arms were removed from the rack). While I removed the bolts with the car on the ground, I wouldn't recommend installing them without the tires in the air. Using just one of the bolts I aligned the steering mechanism back in the rack so it was a snap to get the first arm lined up and the bolt started (don't forget the plate). Then remove the first alignment bolt you installed, load up the last arm with the bushing and install the last arm. Trying to install both bolts at the same time when they are tied together with that brace is near impossible. The locking tab went on smooth with an over sized socket (17mm) and a long breaker bar using leverage from the intake to seat it fully. If you have high miles on your SAAB, installing these can be a challenge but nothing an experienced car-crafter can't get done.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x ATF Saab 3309 (Automatic 02->)
3 x Shifter Alignment Pins (Set 2)
2 x 9-5 Wheel 10-Spoke 16in.
6 x PPC - Upgrade from stage 1 to stage 3
3 x T5 3.0 Bar Map Sensor Adaptor
3 x IAT Weld Bung T5/Bosch
4 x Injectors Siemens 80lb 875cc (set 4)
1 x 9-3 ng900 Hood Protection Strip
1 x Air Filter 06 version (All 9-5)
1 x 9-3/NG900 Shift Knobs Leather
1 x Saab black Keychain
2 x SCNA Christmas Calendar
1 x Viggen Titanium KeyChain
2 x Clear Little Fender Blinkers Factory Saab
1 x c900 Performance Brake lines
1 x Limit Strap Coilover Add On Kit
2 x Replacement V6 Coolant Cap
2 x B207 Coolant Cap
2 x Con Rods V6 2.8L 155.8mm
1 x Oil Cap GM "HHR"
2 x Shift Rod Bushings
1 x PPC 3 Volvo Diagnostic System
4 x Weld Bungs -Taper- Race Only
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Brake Vac pump seals
3 x BSR Optiflow Intake 4cyl
2 x BSR Optiflow Intake V6 2.8t
2 x Front Camber Adjustment Bolts
2 x 3 Point Hardware
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
3 x Shifter Mount Kit 93ss
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Downpipe 2.8T XWD (4wd)
1 x Downpipe 2.8T FWD (2wd)
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Metal Steering Wheel Buttons
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Downpipe Hardware Kit
1 x BSR 9-5 3.0T V6 200Hp
1 x Fuel Line Clip
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Midpipe 2.0T 07-11 FWD (2wd)
2 x BSR Optiflow Intake 4cyl w SAI
1 x Hood Emblem 9-3 SS/sc 03- All
2 x Midpipe 2.8T XWD (4wd)
1 x Midpipe 2.8T FWD (2wd)
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x InjectorDynamics 725cc For 2.8V6 (Set6)
2 x ShortShift Kit 93ss
1 x V6 Tank Float - SparePart
1 x Injectors 175hp Stg3 (Set4)
1 x Floormats BSR 9-3SS/SC
1 x Headlight Connector Repair Kit 9-3SS 9-5
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Coreganizer
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x Sparkplugs 9-3SS
2 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
3 x Basic Subframe Brace
2 x Injectors Siemens 60lb 630cc (set 4)
2 x Head Bolt Washers
2 x Universal / Special Request
1 x Map/MAT sensor weld bung
2 x Intake Flange B2x4 T5
1 x Fuel Pressure Regulator 4.0 bar
3 x Rivetnuts Pair (2pcs)
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Shifter Mount Kit Cobalt/ HHR
2 x K&N Filter Service Kit
1 x Custom Brake Lines RR 300mm Kit
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x v6 2.8t SAI Delete Kit
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Oil Cap 9-3SS V6 "Ghost"
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x AEM Wideband Gauge Kit
1 x Steering Coupler 9-3 99-02
1 x 9000 Shifter Bushing Repair Kit
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Turbo to Downpipe Flange B207
1 x B207 Upper Radiator Coolant T
1 x Optical Cable Connector (Onstar Delete)
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Moog Ball Joint
1 x Mat Set Textile Jet Black 9-5 10-
1 x Mat Set Black Rubber 9-5 10-
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
$23,326.20
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail