$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
6 x T7 Injector Spacer Kit
6 x Cat Back Exh for 9-5 Aero 04-, All 06-
5 x Exhaust manifold Stud Kit
5 x 9-5 Intercooler ETS
1 x c900 Performance Brake lines
5 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Limit Strap Coilover Add On Kit
3 x Headbolts (New Style)
3 x Mass Airflow Meter T7
2 x Coolant Bypass Valve 9-5
2 x Genuine Saab 4cyl Oil Filters
4 x Adaptor Harness Handsfree 01-
3 x Cigarette Lighter
2 x 9-5 Textile Mats 98-07
1 x Bulb Switch Light
5 x Floormats BSR 9-5
5 x ARP Exhaust Manifold Stud kit Stainless
7 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Saab black Keychain
1 x Viggen Titanium KeyChain
3 x Fog light Replacement Panels 99-01
1 x Hood Emblem 9-5 All
2 x Throttle Body T7
2 x Valve Cover Gasket Set 4cyl
1 x Front Camber Adjustment Bolts
6 x Shift Rod Bushings
4 x V6 Tank Float - SparePart
2 x v6oilcoolplate
2 x Rivetnuts Pair (2pcs)
1 x Head Bolt Washers
2 x Moog Ball Joint
1 x 9-3 ng900 radio wires
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Brake Vac pump seals
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Machined Control Arm Kit
1 x Oil Filter Re-locator
1 x Intake Flange B2x4 T5
3 x T7 3.5 Bar Fuel Pressure Regulator
3 x Filter 9-5 Cabin Air
1 x Basic Subframe Brace
2 x Headlight Bulb H7 Longer Life
2 x Air Filter 06 version (All 9-5)
1 x Oil Pressure Switch
3 x Crank Vent Kit #6 T7 4cyl
2 x Crush Sleeve F35 F25
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Transmission Nut F35 F25
3 x 3 Point Hardware
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x Brembo Brake Kit 315mm 9-5 02-->
2 x 9-5 High Performance Brake Line Kit
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Viggen Front Brake Disk Pair 308mm
2 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x 9-5 Rear Brake rotor See Description
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Replacement V6 Coolant Cap
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
3 x PPC - Upgrade from stage 1 to stage 3
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
3 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Injectors Green Giant 42lb (set 4)
2 x 9000 Shifter Bushing Repair Kit
2 x 9000 Intercooler ETS
1 x Open Air Intake 9000 93-98
2 x Clear Little Fender Blinkers Factory Saab
1 x Drop in Sport Filter 9-5
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Aero Clutch Kit 9-5
1 x Midpipe 2.8T XWD (4wd)
1 x Oil Cap GM "HHR"
2 x Forge Bypass Valve Cobalt/HHR TC
1 x Balance Shaft Tensioner Delete
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
3 x Con Rods V6 2.8L 155.8mm
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Direct Ignition T7 Black
2 x PPC 3 Volvo Diagnostic System
1 x SCNA Christmas Calendar
2 x Downpipe Hardware Kit
3 x InjectorDynamics 725cc For 2.8V6 (Set6)
2 x B207 Coolant Cap
2 x v6 2.8t SAI Delete Kit
1 x Viggen Fog Air Intake
3 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Brembo Kit 315mm Hawk HPS Pads
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x 9-5 Shift Knobs Leather
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x 9-5 Aero Sill Protection
1 x ATF Saab 3309 (Automatic 02->)
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Turbo to Downpipe Flange B207
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-5 Open Air Prefilter
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Optical Cable Connector (Onstar Delete)
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x BSR Optiflow Intake 4cyl
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x v6 header flange
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Oil Cap 9-3SS "Ghost"
1 x Slave Cyl
1 x Oil Cap 9-3SS V6 "Ghost"
2 x BSR Optiflow Intake 4cyl w SAI
1 x Midpipe 2.8T FWD (2wd)
1 x Short Shifter HHR Cobalt F35 F40
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Rear Brake Pads 9-5 Later Style
1 x BSR 9-5 260Hp 2006-
1 x Rear Pedestal Spoiler 9-3 SS
1 x BSR 9-5 2010-2011 V6 300Hp
1 x BSR Optiflow Intake V6 2.8t
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Downpipe 2.8T XWD (4wd)
$45,597.01
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail