$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Clear Little Fender Blinkers Factory Saab
1 x 9-5 Shift Knobs Leather
6 x ATF Saab 3309 (Automatic 02->)
3 x Aero Clutch Kit 9-5
2 x 9-5 Wheel 10-Spoke 16in.
3 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x Air Filter 06 version (All 9-5)
1 x "Griffin" Valve stem caps
2 x 9-3 ng900 Hood Protection Strip
1 x Injectors Siemens 80lb 875cc (set 4)
2 x Intake Flange B2x4 T5
1 x AEM Wideband Gauge Kit
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
3 x IAT Weld Bung T5/Bosch
1 x Injectors Siemens 60lb 630cc (set 4)
3 x T5 3.0 Bar Map Sensor Adaptor
2 x Head Bolt Washers
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Injectors Green Giant 42lb (set 4)
1 x Universal / Special Request
2 x Map/MAT sensor weld bung
1 x Fuel Pressure Regulator 4.0 bar
2 x PPC - Upgrade from stage 1 to stage 3
2 x Header Flange Stainless Blended Transition B2x4,B2x5
3 x B207 Coolant Cap
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Fog light Replacement Panels
1 x BBS Center Cap for 9-2x RK small caps
2 x 20th Viggen logo Shifter Top
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Basic Subframe Brace
4 x Exhaust Clamp Kit
4 x Exhaust manifold Stud Kit
2 x Throttle Bend for T5 94-99
3 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Fog light 9-3 Right 99-00
3 x Rear Engine Mount 4cyl
1 x Direct Ignition T7 Black
2 x Mass Airflow Meter T7
2 x Genuine Saab 4cyl Oil Filters
2 x Steering Rod Bushings NG900/93
4 x Crush Sleeve F35 F25
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Turbo Conversion Pipe 900 9-3 T5
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
3 x Fuel Line Clip
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
3 x T7 Injector Spacer Kit
2 x 9-5 Blend Flap Limit Lever 99-04
1 x Steering Coupler 9-3 99-02
3 x Replacement Hardware Pack 6-Point
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Rear Camber Shims Kit 6pcs
1 x Cat back for Viggen 2.5in
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Viggen Fog Air Intake
1 x Crank Vent Kit #6 T7 4cyl
3 x Direct Ignition T5 RED
2 x Rear spring perches Adjustable NG900/9-3
2 x Oil Cooler Adaptor B2X5
1 x Replacement Filter for Open air 9-3 T7
2 x Machined Control Arm Kit
2 x Bulb Switch Light
2 x Mat Set Textile Parchment 9-5 10-
2 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Sparkplugs 9-3SS
1 x Mat Set Textile Shark Grey 9-5 10-
3 x Viggen Clutch Kit 99-02
3 x Valve Cover Gasket Set 4cyl
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Floormats BSR 9-3 99-02 900 94-98
2 x 9-3 ng900 radio wires
2 x Oil Pressure Switch
1 x Turbo Bypass Valve
1 x Flywheel Twin Disk 7.25in B2xx
1 x Viggen Front Brake Disk Pair 308mm
2 x Rear Pedestal Spoiler 9-3 SS
2 x Rear Rotors PAIR 292mm Plain (Code: BB)
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
4 x Slave Cyl
2 x Shifter Top Ghost Logo
2 x Transmission Nut F35 F25
1 x JE Piston Rings 90.0mm 235/205
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Headlight Connector Repair Kit 9-3SS 9-5
2 x Oil Cap 9-3SS V6 "Griffin"
2 x Shift Rod Bushings
1 x Remote Button NG900
2 x Throttle Body T7
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Coolant Bypass Valve 9-5
1 x Injectors 175hp Stg3 (Set4)
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
2 x Metal Steering Wheel Buttons
1 x Cabin Vent Fan
3 x Headbolts (New Style)
2 x Con Rods V6 2.8L 155.8mm
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Hood Emblem 9-3 SS/sc 03- All
2 x Shifter Mount Kit 93ss
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
2 x Midpipe 2.8T FWD (2wd)
3 x Shifter Alignment Pins (Set 2)
2 x 4 Cyl 2.0 Coolant Tank
2 x Replacement V6 Coolant Cap
3 x 9000 Shifter Bushing Repair Kit
1 x 3 Point Hardware
1 x 9-5 Aero Sill Protection
2 x K&N Filter Service Kit
3 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
2 x Griffin logo Shifter Top
1 x ARP Ring Gear Bolts F25/F35
2 x Antenna Plug NG900/9-3 hatchback
1 x Short Shifter HHR Cobalt F35 F40
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x B207 Upper Radiator Coolant T
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Balance Shaft Tensioner Delete
1 x Upgrade Valve Springs T5 Cars
2 x Limit Strap Coilover Add On Kit
3 x MTF0063 Manual Gear oil
1 x Drop in Sport Filter 9-5
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x 9-5 Open Air Prefilter
1 x Filter 9-5 Cabin Air
1 x Troll Head Plug
1 x 9-3 Rear Ashtray
1 x T7 Head Plug NGK
1 x SCNA Christmas Calendar
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Saab black Keychain
1 x Oil Filter Re-locator
$37,682.95
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail