$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x ATF Saab 3309 (Automatic 02->)
4 x K&N Filter Service Kit
3 x Shifter Alignment Pins (Set 2)
2 x Short Shifter HHR Cobalt F35 F40
3 x Forge Bypass Valve Cobalt/HHR TC
2 x Saab black Keychain
2 x SCNA Christmas Calendar
1 x Viggen Titanium KeyChain
3 x MTF0063 Manual Gear oil
1 x Intake Flange B2x4 T5
3 x PPC - Upgrade from stage 1 to stage 3
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Moog Ball Joint
2 x Universal / Special Request
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Head Bolt Washers
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
3 x 9-5 Aero Sill Protection
1 x BSR 9-5 260Hp 2006-
2 x Coolant Bypass Valve 9-5
1 x Exhaust manifold Stud Kit
1 x Downpipe Hardware Kit
2 x Filter 9-5 Cabin Air
1 x Hood Emblem 9-5 All
1 x Rear Camber Shims Kit 6pcs
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x Fuel Line Clip
1 x Slave Cyl
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
2 x Headlight Bulb H7 Longer Life
2 x 9-5 Blend Flap Limit Lever 99-04
2 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Front Camber Adjustment Bolts
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Oil Pressure Switch
2 x Air Filter 06 version (All 9-5)
1 x Aero Clutch Kit 9-5
1 x Mass Airflow Meter T7
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x 9-5 Intercooler ETS
2 x Clear Little Fender Blinkers Factory Saab
2 x Shift Rod Bushings
2 x Crush Sleeve F35 F25
2 x Crank Vent Kit #6 T7 4cyl
1 x T7 Injector Spacer Kit
1 x Fog light Replacement Panels 99-01
2 x Basic Subframe Brace
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Shifter Mount Kit Cobalt/ HHR
2 x IAT Weld Bung T5/Bosch
1 x Front Camber Adjustment Bolts
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Replacement Filter for Open air 9-3 T7
2 x Drop in Sport Filter 9-5
1 x Headbolts (New Style)
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Throttle Body T7
1 x 9-5 Open Air Prefilter
1 x Head Stud Kit all 4cyl
1 x Genuine Saab 4cyl Oil Filters
1 x B207 Upper Radiator Coolant T
1 x Viggen Front Brake Disk Pair 308mm
1 x Oil Cooler Adaptor B2X5
$12,716.63
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail