$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x ATF Saab 3309 (Automatic 02->)
2 x 9000 Shifter Bushing Repair Kit
2 x Limit Strap Coilover Add On Kit
3 x B207 Coolant Cap
1 x Viggen Titanium KeyChain
1 x Saab black Keychain
1 x Troll Head Plug
2 x SCNA Christmas Calendar
2 x T7 Head Plug NGK
1 x Con Rods V6 2.8L 155.8mm
1 x Replacement V6 Coolant Cap
2 x PPC 3 Volvo Diagnostic System
1 x Rivetnuts Pair (2pcs)
1 x Universal / Special Request
1 x Map/MAT sensor weld bung
1 x Direct Ignition T5 RED
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Genuine Saab 4cyl Oil Filters
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 20th Viggen logo Shifter Top
1 x Replacement Hardware Pack 6-Point
1 x Exhaust Clamp Kit
2 x ARP Exhaust Manifold Stud kit Stainless
2 x Clear Little Fender Blinkers Factory Saab
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Turbo Conversion Pipe 900 9-3 T5
1 x Head Stud Kit all 4cyl
1 x T7 Injector Spacer Kit
2 x 9-3 ng900 Hood Protection Strip
1 x Fog light 9-3 Right 99-00
1 x 4340 Connecting Rods B204 B235
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Oil Filter Re-locator
1 x Balance Shaft Tensioner Delete
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x 9-3 /NG900 Grille
2 x T7 3.5 Bar Fuel Pressure Regulator
2 x Fog light 9-3 left 99-00
1 x Oil Cooler Adaptor B2X5
2 x Headbolts (New Style)
1 x Flywheel Twin Disk 7.25in B2xx
1 x Rear Engine Mount 4cyl
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Basic Subframe Brace
2 x Replacement Flywheel Insert NG900/9-3
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Machined Control Arm Kit
3 x Shift Rod Bushings
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Aluminum Flywheel For NG900/9-3
1 x Transmission Nut F35 F25
1 x Rear Camber Shims Kit 6pcs
1 x Rear spring perches Adjustable NG900/9-3
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Shifter Top Ghost Logo
1 x Steering Rod Bushings NG900/93
1 x Steering Coupler 9-3 99-02
1 x Slave Cyl
2 x ARP Ring Gear Bolts F25/F35
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Shift Knobs Leather
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Aero Sill Protection
1 x 9-5 Wheel 5-Spoke Twin 17in
2 x Antenna Plug NG900/9-3 hatchback
1 x 9000 Intercooler ETS
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Downpipe 2.8T XWD (4wd)
1 x 9-3 ng900 radio wires
1 x Filter 9-5 Cabin Air
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Fuel Line Clip
1 x c900 Performance Brake lines
1 x Crank Vent Kit #6 T7 4cyl
1 x Throttle Bend for T5 94-99
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Injectors Green Giant 42lb (set 4)
1 x Open Air Intake 9000 93-98
1 x Exhaust manifold Stud Kit
1 x Crush Sleeve F35 F25
1 x 9000 High Performance Brake Line Kit '95-'98
1 x MTF0063 Manual Gear oil
1 x Griffin logo Shifter Top
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Fog light Replacement Panels
1 x Rod Bearings only Pauter Rods
1 x Upgrade Valve Springs T5 Cars
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Midpipe 2.8T FWD (2wd)
$17,284.70
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail